Abstract:Double-pipe heat exchangers are widely used in the high-pressure and high-temperature applications for their simple and tight tube-in-tube configuration, but therefore normal and stable operation of such pressure-bearing equipment turns to be of greater significance because potential safety risks and economic losses will be aroused if failures occur on them. To deal with this issue, abundant researches have been conducted so far, however most of them focused on the flow and fluid characteristics by numerical simulation and experimental verification, while little attention was paid to the actual cases from the engineering practice. In this paper, such an actual failure case study concerning leakage on the jacket pipe of one double-pipe heat exchanger in a high-pressure polyethylene facility is addressed. In order to find out the causes of this failure, investigation including materials inspection, chemical phase analysis, microscopic morphologies observation, micro-area chemical compositions detection and finite element analysis etc. was carried out. The results indicated that the leakage was firstly induced by the uniform corrosion and the under-deposit corrosion successively, and then stimulated by the effect of erosion from the complicated fluid characteristics around the tee structure. Finally, the related mechanisms of this synergistic effect between corrosion and erosion were discussed, and the pertinent countermeasures from both design and maintenance point of view were proposed, including descaling of the fouled inner pipe, improvement of the circulation cooling water quality, and upgrading of the pipe materials etc. Achievement of this paper will supplement the failure cases database of double-pipe heat exchangers, based on which design optimization and failure prevention will be possible.

Failure Analysis on Pipes of Split Type Air-conditioner and Improvement Method

Analysis of Superheater’s Pipe Wall Overtemperature by Fault Tree Diagnose

Corrosion Failures of High Temperature Heat Pipes

Application of FEM Software ANSYS to Pipes Design of Air-Conditioner

Failure Analysis on Fin Tube Corrosion of Air-cooled Heat Exchanger

FRACTURE ANALYSIS OF THE PIPES FOR EXCHANGING BOILER'S SURPLUS HEAT

A laboratory study of the failure analysis of copper tube used in the air conditioning heat exchanger

Failure Analysis of Collecting Pipe Head Used in Ammonia Refrigerating System

FAILURE ANALYSIS OF BOILER TUBE

Failure analysis of air-conditioning system of domestic rolling stock based on fuzzy fault tree

Cracking Analysis on Water Cooling Wall Pipe in Power Plant

Failure Analysis on Leaked Jacket Pipe of Double-Pipe Heat Exchanger in High-Pressure Polyethylene Facility

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Experimental and simulative failure analysis of reformer furnace outlet manifolds serviced in aromatic plant

Failure Analysis on Premature Fracture of Polyethylene Pipe for Floor Heating System

FAILURE ANALYSIS OF A STAINLESS STEEL DIVERSION TUBE INSIDE A BELLOWS

Analysis on failure tube bundles of domestic air cooler used in hydrocracking unit

Corrosion Failure of Bellows Type Expansion Joint in Heat-supply Pipeline

Failure Analysis of Leakage Occurred in Tee in Steam Pipeline Connected to Heating Furnace

Discussion on Fin Structure of Heat Pipe in Energy Saving for Air-conditioning and Ventilating System

Failure analysis and optimization of high-pressure pipe in carbon dioxide heat pump air conditioning system