Abstract:Double-pipe heat exchangers are widely used in the high-pressure and high-temperature applications for their simple and tight tube-in-tube configuration, but therefore normal and stable operation of such pressure-bearing equipment turns to be of greater significance because potential safety risks and economic losses will be aroused if failures occur on them. To deal with this issue, abundant researches have been conducted so far, however most of them focused on the flow and fluid characteristics by numerical simulation and experimental verification, while little attention was paid to the actual cases from the engineering practice. In this paper, such an actual failure case study concerning leakage on the jacket pipe of one double-pipe heat exchanger in a high-pressure polyethylene facility is addressed. In order to find out the causes of this failure, investigation including materials inspection, chemical phase analysis, microscopic morphologies observation, micro-area chemical compositions detection and finite element analysis etc. was carried out. The results indicated that the leakage was firstly induced by the uniform corrosion and the under-deposit corrosion successively, and then stimulated by the effect of erosion from the complicated fluid characteristics around the tee structure. Finally, the related mechanisms of this synergistic effect between corrosion and erosion were discussed, and the pertinent countermeasures from both design and maintenance point of view were proposed, including descaling of the fouled inner pipe, improvement of the circulation cooling water quality, and upgrading of the pipe materials etc. Achievement of this paper will supplement the failure cases database of double-pipe heat exchangers, based on which design optimization and failure prevention will be possible.

Failure Analysis of Bursting on the Inner Pipe of A Jacketed Pipe in A Tubular Heat Exchanger

Failure Analysis on Leaked Jacket Pipe of Double-Pipe Heat Exchanger in High-Pressure Polyethylene Facility

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

BURST FAILURE ANALYSIS OF PLASTIC ANISOTROPIC THICK-WALLED CYLINDRICAL VESSELS SUBJECTED TO COMBINED PRESSURES

Theoretical Assessment of Burst Failure of Internally Pressurized Defect-Free Pipelines with Plastic Anisotropy

Failure analysis of a reinforced thermoplastic pipe used in an oil transportation system

Failure Analysis on Water Wall Tube Burst of Heating Furnace

Failure Analysis on Bursted High Temperature Steam Pipe of Heavy Oil Well

Failure Analysis on Abnormal Leakage of Shell and Tube Heat Exchanger in Specialty Chemical Plant

FAILURE ANALYSIS OF BOILER TUBE

Failure Analysis of a C-276 Alloy Pipe in a Controlled Decomposition Reactor

Corrosion Failure Analysis for Heat Transfer Tube in Quick Cooled Oil-Dilute Steam Heat Exchanger

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Failure Analysis on Unexpected Fracture of the Hydraulic Expansion Mandrel for Tube to Tubesheet Expanding in the Steam Generator of Nuclear Power Plant

Failure Analysis on Abnormal Bursting of Heat Transfer Tubes in Spiral-Wound Heat Exchanger for Nuclear Power Plant

Failure Analysis of Abnormal Bulging and Cracking for High-Pressure Steam Pipe

Failure Analysis on Premature Fracture of Polyethylene Pipe for Floor Heating System

Failure Analysis of Stainless Steel Heat Exchanger Tubes in a Petrochemical Plant

Failure Analysis of an Elbow Tube Break in a Pyrolysis Furnace