Abstract:As a critical component of pressure equipment, ellipsoidal head is widely used in the fields of petrochemical industry and nuclear plant.The design of ellipsoidal head is so important to guarantee the safety and economy of the pressure equipment.Based on the Chinese standards GB/T 150 and JB 4732, ASME BPVC Section Ⅲ.division 1-Subsection NE, Code Case N-284, SectionⅧ division 1 and division 2, and the European Standard EN 13445, the design methods for internally pressurized ellipsoidal head were discussed and compared in detail.ASME Codes and EN 13445 adopt the design methods based on various failure modes of internally pressurized ellipsoidal head.However, the Chinese standards GB/T 150 and JB 4732 adopt the strength design methods based on maximum stress and limit pressure, respectively.The design equation for preventing local buckling failure was not presented in the Chinese standards, which was disadvantageous for the design of large-scale thin-walled ellipsoidal head.The design results of JB 4732 were too conservative, which was not economical.Moreover, it concluded that there was a defect in these design methods that the effect of both strain hardening and large deflection was ignored.Therefore, it will be a good suggestion to improve the design methods of internally pressurized ellipsoidal head for Chinese standards.

The Analysis Methods of Reinforcements for Openings in Cylindrical Vessels in GB 150—2011

Study on Methods for the Reinforcement of Pressure Vessels with Large Openings

Reinforcement Method of Large Openings in Cylindrical Shells

Comparison of design methods for internally pressurized ellipsoidal head

The Method of Design by Analysis for Cylindrical Pressure Vessels with Spherically Dished Head

Internal Wind Pressures and Buckling Behavior of Large Cylindrical Floating-Roof Tanks under Various Liquid Levels

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Discussion on Thickness Formula of Cylindrical Shell under Internal Pressure

Advances in "design by Analysis" Methods for Pressure Vessels

A Universal Design Method Based on Analysis for Cylindrical Shells with Nozzles Due to Internal Pressure, External Forces and Moments: Part II

ANALYSIS OF BENDING MOMENT IN THE DESIGN OF REINFORCEMENT OF LARGE OPENING IN CYLINDER AS PER ASME CODE

Introduction for Design-by-analysis of CEN's Unfired Pressure Vessel

A New Design Method For Axially Loaded Thin-Walled Cylindrical Shells Based On Elasto-Plastic Buckling Analysis

Localized Perturbation Load Approach for Buckling Design of Thin-Walled Steel Cylindrical Shells under Partial Axial Compression

Pressure Vessel Opening Reinforcement Analysis and Various Kinds of Reinforcing Method Comparison

Reliability-based design on centrifuge concrete filled steel tubular members

An Analytical Method for Cylindrical Shells with Nozzles Due to Internal Pressure and External Loads-Part Ii: Design Method

A study of ultimate strengths of typical longitudinal girders with openings in container ships

A Stress Analysis Method for Cylindrical Shells With Nozzles Subjected to Internal Pressure, External Forces and Moments

Analytical Study on the Buckling of Cylindrical Shells with Stepwise Variable Thickness Subjected to Uniform External Pressure

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria