Abstract:Limit pressures and corresponding maximum local membrane Stress Concentration Factors (SCF) are assessed for two orthogonally intersecting thin-walled cylindrical shells subjected to internal pressure. The limit pressures of 81 models with parameters ρ=d/D≤0.8, D/T≥10, d/t≥10, λ=d/DT≤8 and d/D≤t/T≤2 are calculated using inelastic analyses by the 3D finite element method (3D FEM) in which the material is elastic-perfectly plastic. The plastic collapse pressures obtained by 3D FEM are in good agreement with test results presented by previous authors. The local membrane SCF at the intersections of two cylindrical shells subjected to the limit pressure load is calculated by elastic thin shell theoretical solutions presented by Xue and Hwang. The local membrane SCF decreases significantly as t/T increases, and decreases little as d/DT decreases when D/T is fixed. The local membrane SCF increases significantly as D/T increases, and varies little as d/DT increases when t/T is constant. The local membrane stress criterion km≤2.2 for reinforcement design of openings in a cylindrical pressure vessel subjected to internal pressure can be accepted generally except for a few cases of large thickness ratio t/T, and small opening ratio ρ.

Study on Methods for the Reinforcement of Pressure Vessels with Large Openings

Pressure Vessel Opening Reinforcement Analysis and Various Kinds of Reinforcing Method Comparison

Explosive Experiment of Mild Steel Pressure Vessel and Research on Formula of Explosive Stress

Reinforcement Method of Large Openings in Cylindrical Shells

Finite Element Analysis of Opening Reinforcement for Strain Strengthening Pressure Vessel

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

Strength Differential Effect and Influence of Strength Criterion on Burst Pressure of Thin-Walled Pipelines

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Limit pressure and design criterion of cylindrical pressure vessels with nozzles

Elastic-Plastic Finite Element Analysis of the Internal Pressure Vessels with Large Nozzles

The Analysis Methods of Reinforcements for Openings in Cylindrical Vessels in GB 150—2011

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Test Research on Limit Load of Spherical Vessel with Elliptical Nozzle

Effect of Openings on Elephant’s Foot Buckling of Large Oil Tanks

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

PLASTIC ANALYSES OF STRUCTURES AND FAILURE ASSESSMENT OF PRESSURE VESSELS AND PIPING WITH VOLUMETRIC DEFECTS

Advances in "design by Analysis" Methods for Pressure Vessels

Experimental and Numerical Study of Cracking Behavior of Openings in Concrete Dams

Stress Analysis and Strength Evaluation of High Pressure Reactor

An experimental and numerical investigation on ultimate strength of stiffened plates with opening and perforation corrosion