Abstract:Deformation and leakage of the metal–metal lap structures. This work focused on the leakage of the composite pressure vessel with a structure consisting of an aluminum alloy inner liner, a composite winding layer, and an aluminum covering. Through applying the finite element simulation approach and leakage rate test, it was found that the average strain of the winding layer in the lap region at the pressure of 46 MPa is 0.0078. Additionally, the leakage rate of the covering adhesive joint was investigated by considering the deformation, revealing that the leakage rate increases with increasing test pressure. The leakage rate at the lap region with a length of 18 mm is 2.05 × 10−7 Pa·m3/s at 0.0078 strain decreasing by 1.46 and 2.31 times compared to those under 12 and 7 mm lengths, respectively. The leakage rate exhibits a strict inverse correlation with the length of the leakage path under a pressure of 0 MPa. Additionally, when the deformation remains below the critical strain threshold (approximately 0.6%), the relationship between pressure and leakage rate shows a linear positive correlation. When the deformation of the component exceeds the critical strain threshold, the leakage rate of the component is significantly affected by its deformation and an increase in overall deformation results in a greater increase in leakage rate. The relationship between the two exhibits a non‐linear trend. This work provides strong technical support for the leakage assessment of composite pressure vessels. Highlights Deformation of the pressure vessel was analyzed through theoretical and simulation approaches. Establishing the relationship between deformation and pressure in metal–metal lap structures. Leakage analysis for different metal–metal lap lengths and deformation conditions.

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Investigation on the leakage resistance of metal‐fiber‐metal pressure vessel coupled with deformation

Experiments and Numerical Simulations on Laser Welding Deformation of Thin Plate Considering Constraint Clamp

Thermal-Elastic-Plastic Finite Element Analysis for Laser Welding Deformation of Thin Plate

Analysis of influence of initial gap of laser-arc hybrid butt welds on inherent strain and welding deformation of a pipe structure

Comparative Study of Welding Deformation of a Stiffened Panel under Various Welding Procedures

Finite Element Analysis on Pressure Cylinder Component of Oil Damper

Finite Element Modeling of Laser Spot Welded Lap Joint

Analysis of Welding Deformation of 304L Stainless Steel Structure

Finite Element Analysis of Laser Welding Residual Stress and Distortion in Welded Joints of TC4 Titanium Alloy

Experimental and Numerical Investigation of Single-Pass Laser Welding of 20 Mm-Thick High-Strength Steel under Reduced Ambient Pressure

Elastic-Plastic Finite Element Analysis of the Internal Pressure Vessels with Large Nozzles

Role of Ambient Pressure in Keyhole Dynamics Based on Beam Transmission Path Method for Laser Welding on Al Alloy

Theoretical and Experimental Study on Laser Compound Forming of Plate

Experimental Study on Forming Limit Diagram of Laser Welded Tube Hydroforming

Plastic Deformation Mechanisms and Their Threshold Pressures of Ti6Al4V Thin-Walled Structures Induced by Laser Peen Forming

3-D Finite Element Analysis of Welding Residual Stress for Half-Pipe Jacket Made of 304 Stainless Steel

EXPERIMENTAL STUDY ON THE STRENGTH OF COMPLEX THIN-WALLED STRUCTURES UNDER INTERNAL PRESSURE

Bead Formation Characteristics in Laser Welding of High-Strength Steel under Subatmospheric Pressures

Research of Complicated Ship Structure Welding Distortion Based on ANSYS