Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Simulation of laser brazing of sheet panels and parametric studies of thermally-induced distortion reduction

Numerical Simulation and Experimental Analysis of Thermal Conduction and Stress in Laser Cladding Repair of Thin-Walled Parts

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Numerical Simulation Research on Laser Shock Forming of Thin Metal Sheet

Experimental and numerical investigation on laser beam forming of steel sheets

Numerical simulation of the laser welding process in butt-joint specimens

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Optimization of Laser Cladding Forming Parameters by Numerical Simulation to Minimize the Cracking Posibilitys

Numerical Simulation of Stainless Steel-Carbon Steel Laminated Plate Considering Interface in Pulsed Laser Bending

Thermomechanical Process Simulation and Experimental Verification for Laser Additive Manufacturing of Inconel®718.

FE Simulation of Laser Curve Bending of Sheet Metals

Effect of Interlayer Cooling Time, Constraint and Tool Path Strategy on Deformation of Large Components Made by Laser Metal Deposition with Wire

Numerical Simulation on Laser Full-penetration Welding of Medium-thickness Stainless Steel Plates

Simulation of temperature field and deformation in laser-arc hybrid additive manufacturing

Buckling distortion of laser welded thin plates and its control by dynamic cooling

Optimizing Interfaces in Laser-Brazed Ceramic-Stainless Steel Joints for Hydrothermal Sensors through Finite-Element Modeling

Advances in additive manufacturing process simulation: Residual stresses and distortion predictions in complex metallic components

Development of Efficient Distortion Prediction Numerical Method for Laser Additive Manufactured Parts

Simulation of the elasto-plastic response and residual stresses near metal surface due to laser shock processing

Parameter Optimization for Laser Peen Forming on 6005A-T6 Aluminum Alloy Plates to Enhance the Constrained Deformation of Integral Stiffened Plates

Theoretical and Experimental Study on Laser Compound Forming of Plate