Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Deformation Behaviours of Laser Curve Bending of Sheet Metals

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Numerical Simulation of Temperature Field in Multilayer Heterogeneity Lamination Laser Soldering

Numerical Simulation of Stainless Steel-Carbon Steel Laminated Plate Considering Interface in Pulsed Laser Bending

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Experimental and numerical investigation on laser beam forming of steel sheets

Finite element analysis of AM30 magnesium alloy sheet in the laser bending process

Temperature Simulation of Aluminium Alloy Double-Arc Welding Process on Simplified Conditions

A Three-Dimensional Thermal Finite Element Model of Laser Transmission Welding for Lap-Joint

Effects of Laser Scanning Strategy on Bending Behavior and Microstructure of DP980 Steel

Numerical Simulation on Temperature Field in Laser-Plasma Arc Hybrid Welding

Numerical simulation of laser welding of titanium alloy in dentistry

Improving the accuracy and reliability of temperature field simulation during laser metal deposition

Curved Laser Bending of Titanium Alloy Sheets and Effects of Heat Radiation on Its Microstructure and Property

Analytical and numerical analysis of heat transfer and temperature distribution in laser sintering method

Temperature Field Numerical Simulation of Laser Welding Joint of Stainless Steel Automobile Vent Pipe

Investigation on the bending deformation of laser peen forming with a simplified eigenstrain-based finite element model