Abstract:Sandwich pipe (SP), consisting of two comparatively thin-walled metal tubes and a thick polymer or cement based core, is believed to be a feasible conception to transport hydrocarbons in deep sea. In this paper, the buckle propagation experiments were carried out on small-scale SP test specimens composed of two aluminium tubes and the polypropylene (PP) core. In association with experimental efforts, dedicated finite element models of SP test specimens under external pressure were established to reproduce the local collapse and consequent buckle propagating scenarios using the software ABAQUS, and good agreements were observed between the experimental and numerical results. Then, influencing mechanisms of inter-layer adhesion behaviour on the stress state, cross-section deformation and buckle propagation pressure of SPs were systematically studied, and broad parameter correlation analyses were performed to explore geometric and material properties of two steel tubes and polymer core on the buckle propagation pressure of SPs. The results show that good interface bonding conditions can markedly enhance the buckle propagation pressure of SPs and improve the energy dissipation and the deformation capacity of the structures. The core layer thickness and the ratio of the wall thickness between inner and outer tubes have extremely noticeable effect on the buckle propagation pressure of SPs. Additionally, based upon extensive numerical results, an empirical design expression was developed to conservatively estimate the buckle propagation pressure of SP systems for the no inter-layer adhesion case.

Analysis of the Pressure Expansion of Bridge Plug Tools and Packers by Equivalent Material Method

A computational method for the dynamic load in heavy-vehicle bumping at the bridge expansion joint and analysis of the influencing factors

Buckle Propagation of Sandwich Pipes under External Pressure

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

Structure Optimization of Hydraulic Press Based on FE Analysis

Modeling and analyzing on pressure distribution of plane port pair based on disk-shape gap

Fluid-solid Coupling Analysis of the Pressure Expansion of Packers

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

A Three-Dimensional Analytical Solution for Sandwich Pipe Systems under Linearly Varying External Pressures

Safety analysis of pressure piping containing incomplete penetration under combined loads

Stress Analysis and Assessment of Stream Setting Vessel Based on Elastic Contact Element Method

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Elastoplastic damage analysis and structural optimization of soluble bridge plug based on phase field method

Buckle Propagation Analysis of Deep-Water Petroleum Transmission Pipelines with Axial Tension

Finite Element Analysis of Structural Hot-Spot Stress for Orthotropic Steel Bridge Deck

Finite Element Analysis on the Mechanical Properties of the Combined Fittings With a Long Radius and Double Elbows

Numerical Study on Sealing Performance after Wear of Plug Valve During Opening–closing Process

Burst Pressure of Pipelines with Plastic Anisotropy under Combined Internal and External Pressures

Limit Analysis for Piping Branch Junctions with Local Wall-Thinning under Pressure

Structural analysis of plate-type hydroforming hydraulic press

Advances in "design by Analysis" Methods for Pressure Vessels