Abstract:The characteristics of radial pressure distribution inside side chamber and leakage flow through balancing holes of centrifugal pumps are very important for accurately predicting the axial thrust produced by a balancing system. Therefore, a rapid and sufficiently accurate calculation method is required. An integrated model describing the characteristics of radial pressure distribution inside side chamber and leakage flow rate through balancing holes was established. In this model, the correction coefficient of liquid pressure at side chamber entrance and the discharge coefficient of balancing holes were obtained by experiment. The IS 80-50-315 type single-suction, single-stage, and cantilevered centrifugal pump with the structure of double wear-rings and balancing holes was employed as a model to investigate the characteristics of internal liquid flow of the balancing system. Under different pump flow rates, pump performance curves, radial pressure distribution inside side chamber, and leakage flow rate through balancing holes were examined with different balancing hole diameters. Afterward, the experimental data were compared with the predicted results. The comparisons showed a reasonable consistency. Consequently, according to detailed pump dimensions and operating conditions, the integrated model in current form is recommended for centrifugal pumps, which have low specific speed and are with balancing systems of double wear-rings and balancing holes. This can be used for the prediction of radial pressure distribution inside side chamber and leakage flow rate through balancing holes and can be used both at the design stage and nondesign stage.

Modeling and analyzing on pressure distribution of plane port pair based on disk-shape gap

Analysis of force and leakage in water hydraulic motor' s piston pairs

Numerical Analysis of Sealing Band on Valve Plate in Piston Pump

Research on Oil Film Forming of Port Pair in Axial Piston Pump and its Prediction

Numerical Analysis of Lubrication Property for Port Plate Pair of Axial Piston Pump

Pressure and Flow Characteristic Modeling of Water Hydraulic Axial Piston Pump Based on Variable Fluid Properties

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Leakage Model of Distributing Mechanism in Fuel Piston Pump

Real-time Measurement on Lubrication Characteristic Parameters of Plane Port Pair in Axial Piston Pumps

Numerical Simulation of Cavitating Flow in Water Hydraulic Axial Piston Pump

Modelling and Experiment Study on Fluid Character of Axial Piston Pump

Investigation of the integrated model of side chamber, wear-rings clearance and balancing holes for centrifugal pumps

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

A centrifugal force interaction analysis on the piston/cylinder interface leakage of bent-axis type piston pumps

Analysis on the Leaking Flow Field of the Piston Sector Considering the High Press and High Velocity

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Numerical Analysis for Textured Port Plate of Axial Piston Pump

Modeling and Analysis of the Leakage Performance of the Spherical Valve Plate Pair in Axial Piston Pumps

Numerical Solution for Two-dimensional Steady-state Pressure Distribution on Spherical Port Plate of Axial Piston Machines

Theoretical Analysis on Fluid-Structure Coupling of Hydrostatic Mechanical Seal

New Analytical Leakage Models for Tribological Interfaces in Axial Piston Pumps