Abstract:The wear of oil pump vanes easily leads to the noise and vibration, even results the decrease of volume efficiency and total efficiency. In order to reduce the friction and improve the lubrication between the vane and the pump inner wall, the micro-machining of micro-structure on the oil pump vanes is proposed. First, the micro-V-grooves with the depth ranging from 500 mu m to 50 mu m were micro-grinding on the top of the vanes by a diamond grinding wheel. Secondly, the experiments were conducted to test the actual flow rate, the output power and the overall efficiency of the oil pump with and without the micro-groove vanes. Then, the computational fluid dynamics (CFD) method was adopted to simulate the pump internal flow field. Finally, the micro-flow field between the internal wall of the oil pump and the top of micro-grooved vanes was analyzed. The results shows that the pump overall efficiency increased as the decrease of micro-groove depth from 500 mu m to 50 mu m and not be affected by the rotate speed and working frequency of the pump rotator. Especially the micro-groove with depth of 50 mu m, the actual flow rate, the output power and the overall efficiency reached to the maximum. From CFD simulation, the velocity of the micro-flow between the surfaces of the vane and inner wall was larger than the pump linear velocity when the microstructure depth is larger than 50 mu m, leading to an internal leakage. When the micro-groove depth is between 10-50 mu m, the velocity of the micro-flow was less than the pump linear velocity and no internal leakage was found, but the oil film thickness is too small to be beneficial to lubrication according to the fluid dynamic characteristics. Thus, for the oil pump equipping with micro-grooved vane with the depth of 50 mu m, the internal leakage not only is avoided but the lubrication efficiency is improved and the oil pump efficiency is also enhanced.

Leakage Model of Distributing Mechanism in Fuel Piston Pump

Analysis of force and leakage in water hydraulic motor' s piston pairs

Modeling and analyzing on pressure distribution of plane port pair based on disk-shape gap

New Distributing Mechanism for High Speed Single-Piston Axial Piston Pump

Real-time Measurement on Lubrication Characteristic Parameters of Plane Port Pair in Axial Piston Pumps

Pressure and Flow Characteristic Modeling of Water Hydraulic Axial Piston Pump Based on Variable Fluid Properties

A centrifugal force interaction analysis on the piston/cylinder interface leakage of bent-axis type piston pumps

Flow characteristics simulation and low-noise design of fuel piston pump

Numerical Analysis of Sealing Band on Valve Plate in Piston Pump

Low Leakage and High Volumetric Efficiency Research of Seawater Plunger Pump

Characteristics of Volumetric Losses and Efficiency of Axial Piston Pump with Respect to Displacement Conditions

Volumetric Efficiency in Motor-Driven Two-Dimensional Piston Pumps with Leakage and Reverse Flow under High Pressure

THE TRANSITION OF WEAR AND LEAKAGE CHARACTERISTICS OF THE CYLINDER BLOCK/VALVE PLATE INTERFACE IN A WIDE RANGE OF OPERATING CONDITIONS

Modeling and Analysis of the Churning Losses Characteristics of Swash Plate Axial Piston Pump

New Analytical Leakage Models for Tribological Interfaces in Axial Piston Pumps

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump

Leakage Characteristic Identification of Labyrinth Seals on Reciprocating Piston Through Transient Simulations

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Study on Leakage Effect Factors of Two-Stroke Micro Free Piston Swing Engine

The Mechanism Performance of Improved Oil Pump with Micro-Structured Vanes

Analysis on the Flow Leakage in High Pressure Vane Pump