Abstract:This study presents a novel roller piston pump,in which a cam guide-roller type rolling support is adopted to replace the sliding pair support of the swash plate-slipper pair to achieve the oil suction and discharge of the piston cavity.In addition,the shaft distribution is used to replace the original valve plate distribution and the driving shaft is used as the distribution shaft to remove the valve plate structure,which greatly simplifies the design of the axial piston pump.Such a configuration largely reduces the number of sliding friction pairs of the pump,and avoids the influence of the sliding friction pair on it under high-speed and variable-speed conditions.Firstly,mathematical models of the mechanical and volumetric efficiencies of the roller pump are deduced respectively through force analysis and the compressibility equation.Based on the numerical simulation of MATLAB and AMESim,the effects of load pressure and rotational speed on mechanical and volumetric efficiencies are studied respectively,and it is verified that the roller pump has no structural flow pulsation.The prototype pump is then designed and built,along with a special test rig.The outlet pressure,outlet flow,and torque of the pump under different load pressures and rotational speeds are measured,and the mechanical and volumetric efficiencies of the prototype pump under various load pressures and rotational speeds are obtained.The experimental results are in good agreement with the simulated analysis.When the load pressure is 8 MPa and the speed is 5000 r/min,the mechanical and the volumetric efficiencies are 85.5%and 96.8%,respectively.When the speed is increased to 10000 r/min,the mechanical and the volumetric efficiencies are 66.7%and 95.6%,respectively.The experimental results show that the proposed roller piston pump has excellent efficiency under wide-speed and high-speed conditions and can be a potential solution as a fuel pump in aerospace fuel systems.

New Distributing Mechanism for High Speed Single-Piston Axial Piston Pump

Leakage Model of Distributing Mechanism in Fuel Piston Pump

Dynamic characteristics of pilot-operated electro-hydraulic flow distribution system

Simulation Research on Distribution Method of Axial Piston Pump Utilizing Pressure Equalization Mechanism

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

Variable displacement distributor with valve control for axial piston pump/motor

Performance Optimization for High Speed Axial Piston Pump Considering Cylinder Block Tilt

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Design strategy and performance evaluation of novel miniature two-dimensional (2D) piston pump with a dual stacking mechanism

Modeling and Analysis of the Tilt Behavior of the Cylinder Block in a High-Speed Axial Piston Pump

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Structural Design of a Cross Wobble Plate Driving Axial Piston Pump Based on ADAMS and AMESim Co-simulation

Double-rotator and valve plate distribution radial piston pump

A New Design Method for the Transition Region of the Valve Plate for an Axial Piston Pump

Research on the Volumetric Efficiency of a Novel Stacked Roller 2D Piston Pump

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Centrifugal Effects on Cavitation in the Cylinder Chambers for High-Speed Axial Piston Pumps

Design and experimental validation of a valve-distributed water radial piston pump

Comparative Study on Asymmetric and Symmetric Configurations of Valve Plates in Axial Piston Pumps

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump