Abstract:When a vehicle passes over a bridge, it may jump on the bridge due to a damaged expansion joint. The sudden jump induces a heavy dynamic impact on the bridge and therefore damages the bridge deck and girder. The traditional dynamic amplification factor defined by the current bridge design code shows the amplification of the static effects on the bridge. However, it only concerns the stable moving load induced by the vehicle. The sudden vehicle impact due to a damaged expansion joint sometimes exceeds the allowable design load, so it is important to evaluate the dynamic impact in practice. In fact, the dynamic impact can be approximately considered as a contact force between a damped harmonic oscillator and a beam due to the bilateral symmetry of the vehicle; therefore, a model-based approach using the bridge midspan acceleration is proposed in this study to approximately evaluate the impact force, where it is assumed as an exponentially damped sine function. This is a typical parametric model-based inverse problem. The conjugate direction method is used to determine the unknown parameters and the initial values are determined by a simple global search method. Since only five parameters are included, the proposed method is simpler than the conventional basis function-based methods. Numerical simulations were conducted to validate the proposed method. Generally, the proposed method performs well to identify the dynamic impact. In particular, the displacement measured directly from the bridge is preferred since the displacement obtained from the acceleration has numerical errors; the measurement noise in the range of 1% to 5% shows a slight influence on the proposed method; and the error of frequencies and mode shapes greatly affects the proposed method, especially for the maximum force.

A computational method for the dynamic load in heavy-vehicle bumping at the bridge expansion joint and analysis of the influencing factors

Analysis of dynamic load of vehicle bumping at bridge-head using distributed spring-damper element

Dynamical Behavior of Steel Box Girder Bridges Due to Vehicle-Induced Vibration at Expansion Joint

Research on computational method and dynamic characteristics of traffic vibration of steel bridge

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

Site-Specific Fatigue Load Spectrum for Urban Bridges

Response and Vibration Control of Steel Box-girder Bridge When Vehicles Passing through the Expansion Joint

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Research on the impact coefficient of vehicle wheel load on bridge expansion joint by scale model experiment

Dynamic Response of a Vehicle-Bridge Expansion Joint Coupled System

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Analysis on Comfort of Lower Suspended Footbridge Caused by Traffic Load

Determination method of limit vehicle bump height in dynamic load test of simply supported bridge

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application

Evaluation of the Dynamic Impact of a Passing Vehicle on a Bridge Deck Due to a Damaged Expansion Joint

Numerical Investigation of the Vibration Performance of Elastically Supported Bridges Under a Moving Vehicle Load Based on Impact Factor

Failure Mechanism of Expansion Joints in a Suspension Bridge

Dynamic Analysis and Optimization of Vehicle-Bridge Interaction System under Road Roughness and Time Variability of Element Interpolation Function

Impact of Variable Parameters of Expansion Joints and Bearing Supports on the Vehicle-Induced Vibration of Curved Girder Bridges

Dynamic Response Impact of Vehicle Braking on Simply Supported Beam Bridges with Corrugated Steel Webs Based on Vehicle-Bridge Coupled Vibration Analysis

Numerical analysis of vehicle-bridge coupling vibration concerning nonlinear stress-dependent damping