Abstract:In order to more accurately consider the effect of the dynamic vehicle loading caused by the road surface condition (RSC) on the fatigue damage accumulation of bridge components,the deterioration process of the RSC of steel bridges under the given traffic and environmental loading condition was first investigated,and the number of vehicle passages required for the RSC to deteriorate from one class to the next was obtained.Then,the three-dimensional bridge and vehicle models were established respectively.Coupling vibration equations based on the displacement and the interaction force relationships at the contact points of the bridge and vehicle models were solved by the modal superposition technique and the fourth-order Runge-Kutta method in the time domain.In terms of numerical simulations,the impact factors for stress range and the equivalent number of stress cycles,induced by each vehicle passage were obtained under the different RSCs of the main girder of five I-type simply supported steel girder bridges with different span lengths based on AASHTO bridge design specifications.Finally,impact factors and the number of stress cycles for fatigue design,two parameters directly affecting fatigue lifetime of bridges in AASHTO bridgc design specifications were optimized by considering the fatigue damage accumulation effect of dynamic vehicle loading on bridge members during the deterioration process.The procedure of applying the proposed method to improve the Chinese code for fatigue design and evaluation of steel bridges was also discussed.The results show that the impact factor (0.15) specified in AASHTO bridge design specifications for fatigue design is suitable for bridges with span lengths larger than 23m,while for the fatigue design of shorterspan steel bridges,larger impact factor should be adopted.The value of 1 may be adopted as the number of stress cycles for the main girders of steel bridges with span lengths larger than 23 m and the number of stress cycles can be calculated with the proposed equation for bridges with span lengths shorter than 23 m.The proposed approach can be applied to improve the Chinese code for fatigue design and evaluation of steel bridges.

Site-Specific Fatigue Load Spectrum for Urban Bridges

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Study On Fatigue Traffic Loading For Highway Bridges In China

Progress in Fatigue Loading for Highway Steel Bridges

Measurement-Based Vehicle Load Model for Urban Expressway Bridges

An Improved Model for Design Fatigue Load of Highway Bridges Considering Damage Equivalence

Fatigue load model of orthotropic steel deck for port highway in China

Fatigue Performance Evaluation for an Orthotropic Steel Bridge Deck Based on Field Hotspot Stress Measurements

Lifetime fatigue reliability evaluation of short to medium span bridges under site-specific stochastic truck loading

Vehicle Load Spectrum Simulation of Long-Span Bridges

Study on the Model of the Fatigue-loaded Vehicles in Guangzhou Trestle Bridges

Optimization and Application of Fatigue Design Based on AASHTO Code

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Vehicle survey and local fatigue analysis of a highway bridge

Investigation of Highway Bridge Load Effect for Fatigue Reliability Analysis

Fatigue Damage Analysis on Existing Reinforced Concrete Bridge under Overloading

WIM-based vehicle load models for urban highway bridge

Equivalent Wheel Load Approach For Slender Cable-Stayed Bridge Fatigue Assessment Under Traffic And Wind: Feasibility Study

Statistical traffic load model based on WIM measurements for bridge fatigue assessment