Abstract:In the current vehicle-bridge dynamics research studies, displacement impact coefficients are often used to replace the moment and shear force impact coefficients, and the vehicle model is also simplified as a moving-load model without considering the contribution of vehicle stiffness and damping to the system in some concerned research studies, which cannot really reflect the mechanical behavior of the structures under vehicle dynamic loads. This paper presents a vehicle-bridge coupling model for the prediction of dynamic responses and impact coefficient of the long-span curved bending beam bridge. The element stiffness matrix and mass matrix of a curved box girder bridge with 9 freedom degrees are directly deduced based on the principle of virtual work and dynamic finite element theory. The vibration equations of vehicle-bridge coupling are established by introducing vehicle mode with 7 freedom degrees. The Newmark-β method is adopted to solve vibration response of the system under vehicle dynamic loads, and the influences of flatness of bridge surface, vehicle speed, load weight, and primary beam stiffness on the impact coefficient are comprehensively discussed. The results indicate that the impact coefficient presents a nonlinear increment as the flatness of bridge surface changes from good to terrible. The vehicle-bridge coupling system resonates when the vehicle speeds reach 60 km/h and 100 km/h. The moment design value will maximally increase by 2.89%, and the shear force design value will maximally decrease by 34.9% when replacing moment and shear force impact coefficients with the displacement impact coefficient for the section internal force design. The load weight has a little influence on the impact coefficient; the displacement and moment impact coefficients are decreased with an increase in primary beam stiffness, while the shear force impact coefficient is increased with an increase in primary beam stiffness. The theoretical results presented in this paper agree well with the ANSYS results.

Research on the impact coefficient of vehicle wheel load on bridge expansion joint by scale model experiment

A computational method for the dynamic load in heavy-vehicle bumping at the bridge expansion joint and analysis of the influencing factors

Dynamical Behavior of Steel Box Girder Bridges Due to Vehicle-Induced Vibration at Expansion Joint

Research on computational method and dynamic characteristics of traffic vibration of steel bridge

Analysis of dynamic load of vehicle bumping at bridge-head using distributed spring-damper element

Site-Specific Fatigue Load Spectrum for Urban Bridges

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Response and Vibration Control of Steel Box-girder Bridge When Vehicles Passing through the Expansion Joint

Dynamic Response of a Vehicle-Bridge Expansion Joint Coupled System

Evaluation of the Dynamic Impact of a Passing Vehicle on a Bridge Deck Due to a Damaged Expansion Joint

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application

Impact Coefficient Analysis of Curved Box Girder Bridge Based on Vehicle-Bridge Coupling

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Vehicle Load Effect of Long-Span Bridges

Numerical Investigation of the Vibration Performance of Elastically Supported Bridges Under a Moving Vehicle Load Based on Impact Factor

Study of Dynamic Behavior and Influences Induced by Structural Parameter Variations of Self-Anchored Suspension Bridge

Theoretical Analysis and Experimental Study of Vehicle-Bridge Coupled Vibration for Highway Bridges

Measurement-Based Vehicle Load Model for Urban Expressway Bridges

Study on the Influence of Bridge Expansion Joints on Vehicle-Track- Bridge System

Impact of Variable Parameters of Expansion Joints and Bearing Supports on the Vehicle-Induced Vibration of Curved Girder Bridges

Study on the Vertical Stiffness of Bridge Expansion Joints Based on the Vehicle-Track-Bridge Coupled Model