Abstract:It is well known that welding produces thermal stresses which cause distortion of structures and residual stresses which influence buckling strength and brittle fracture strength of welded structures. Cold cracking of the weldment has beem investigated from a mechanical point of view with special attention paid to thermal stresses induced during the cooling stage of a welding thermal cycle.For a better analysis on these subjects, it is necessary to obtain more accurate information on the entire histories of stresses and strains to which the material is subjected during the process of welding. At the instant of welding, a limited portion of the welded joint such as the weldment and the base metal in its vicinity is heated to a very high temperature and therafetr cooled down to room temperature. The thermal cycle proceeds, the temperature distribution changes with time and the mechanical properties of the metals depend on temperature. In order to perform a more reliable analysis, the above mentioned factors should be taken into account. However, there are many difficulties in analysing theoretically practical models, including these effects, by classical methods, and there are only a few reports of their analysis based on simplified assumptions, such as regarding the problem as one dimensional problem or neglecting most of tempe-rature-dependent factors.The authors developed a method of theoretical analysis on this problem based on the finite element method, with consideration of the effects of changes in modulus of elasticity, yield stress and coefficient of expansion of the metal which are dependent on temperature under the assumption that problem is regarded as quasi-static, so that there is no interaction between temperature distribution and stress one. Accordingly, the temperature analysis is carried out independently before the stress analysis. As both analyses take incremental procedure, they can take into consideration of the effects of experience of the material before a stage at the following step of computation. if necessary, such as the rate of cooling on phase transformation, peak temperature on the mechanical properties, etc. in addition to the above mentioned temperature dependent properties. Examples of calculation given here are thermal stresses induced in butt welded joint under a moving electorode and local stresses and strains in RRC specimens during thermal cycle, and they show the usefulness of the method to general cases of welding.

Thermal-Elastic-Plastic Finite Element Analysis for Laser Welding Deformation of Thin Plate

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Experiments and Numerical Simulations on Laser Welding Deformation of Thin Plate Considering Constraint Clamp

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Finite-element inverse analysis of residual stress for laser welding based on a contour method

3D-FEM numerical simulation of welding stress in thin aluminum alloy plate

Analysis of influence of initial gap of laser-arc hybrid butt welds on inherent strain and welding deformation of a pipe structure

Finite element analysis of CFRP and stainless steel laser welding

Review on finite element analysis of welding deformation and residual stress

Finite Element Analysis of Residual Welding Stresses and Deformation for a 5A06 Aluminum Alloy Plate

A Three-Dimensional Thermal Finite Element Model of Laser Transmission Welding for Lap-Joint

Analysis of Thermal Elastic-Plastic Behavior of Metals during Welding by Finite Element Method

Finite element simulation of temperature field for TIG butt welding of thin plate

Welding process simulation under varying temperatures and constraints

ANALYSIS OF THERMAL ELASTIC-PLASTIC STRESS AND STRAIN DURING WELDING BY FINITE ELEMENT METHOD

Numerical Simulation for Full-Penetration Electron Beam Welding of Ti2AlNb Alloy

Numerical simulation of residual stress and deformation on laser welding of "grooved-coat" structure

Numerical Simulation and Experimental Analysis of Thermal Conduction and Stress in Laser Cladding Repair of Thin-Walled Parts

Thermo Mechanical Analysis of Ultrasonic Welding of Metal Joints under Different Control Parameters