EXPERIMENTAL STUDY ON THE STRENGTH OF COMPLEX THIN-WALLED STRUCTURES UNDER INTERNAL PRESSURE

MA Xin,ZHENG JinYang,YUAN Biao,CHEN XiNan,SUN GuoYou

DOI: https://doi.org/10.3321/j.issn:1001-9669.2007.02.009

2007-01-01

Abstract:Rectangular thin-walled structures made of stainless molded units and reinforced with stiffeners have been drawing increasing attentions in drinking industry and water tower applications in recent years.For their complex geometry,analytic solution based on elastic-plastic theory is almost impossible.An experimental investigation on the strength of assembled thin-walled water-tank(ATWWT),which is a typical complex rectangular thin-walled structure subject to internal pressure load was carried out.To investigate the strength and the deformation characteristics of its molded units,a total of 13 tensile samples were tested,and an increase of yield strength up to 42% was found.And the mechanical response of a prototype ATWWT was obtained,where the largest Mises equivalent stress of the control points was located between the convex face and the plain region of the molded units.The failure modes of the protoype ATWWT were found to be buckling of bottom molded units,leaking at the corner of the molded units and fracture of stiffeners.