Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

A novel gate-suppression technique for ESD protection.

Silicon-Controlled Rectifier Stacking Structure for High-Voltage ESD Protection Applications

Study of Turn-on Characteristics of SCRs for ESD Protection with TDR-O and TDR-S TLPs

Design and Analysis of an Area-Efficient High Holding Voltage ESD Protection Device

A novel power-clamp assisted complementary MOSFET for robust ESD protection.

Novel Gate-Voltage-Bias Techniques For Gate-Coupled Mos (Gcmos) Esd Protection Circuits

Design of A Gate-Coupled Electrostatic Discharge Protection Structure

A novel straight through-MOS-triggered SCR for on-chip ESD protection

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Effects of process variation on turn-on voltages of a multi-finger gate-coupled NMOS ESD protection device

A Novel Substrate-Optimized GGNMOS for Low-Voltage ESD Protection in 65 nm CMOS Process

New Electrostatic Discharge Protection Device for VBO High Speed Chip

Very Small Snapback Silicon-Controlled Rectifier for Electrostatic Discharge Protection in 28 Nm Processing.

A Novel ESD Clamp Protection Circuit with Low Leakage Current and High Latch-up Immunity

Comparison of different MOS-triggered SCR structures for on-chip ESD protection

A Novel Technique to Suppress Multiple-Triggering Effect in Typical DTSCRs under ESD Stress

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

A Novel Capacitance-Coupling-Triggered SCR for Low-Voltage ESD Protection Applications

An Improved Ggnmos Triggered Scr for High Holding Voltage Esd Protection Applications

Input ESD protection circuit design with special considerations for gate oxide protection in nanoscale technologies

Novel Nanophase-Switching ESD Protection