Development and Qualification of ITER Current Lead Electrical Insulation
Guoliang Li,Xiongyi Huang,Pierre Bauer,Linlin Fang,Jun Wang,Chao Wang,Zhiheng Dai,Chen Liu,Zheng Gong,Nicholas Clayton,Roland Piccin,Chen-yu Gung,Tingzhi Zhou,Kaizhong Ding,Chenglian Liu,Kun Lu,Yuntao Song,Erwu Niu
DOI: https://doi.org/10.1016/j.fusengdes.2019.01.123
IF: 1.905
2019-01-01
Fusion Engineering and Design
Abstract:The ITER high temperature superconducting current lead is a critical component for the magnet system, which has the benefit of reduction in the heat load of the cryogenic system compare with the conventional lead. The current lead is located in the coil terminal box and dry box at the end of the ITER feeder system. As a warm to cold transition section, the current leads feed the huge current from the power supply system into the coils. At the outer surface of the current lead, one layer of a composite insulation is applied to isolate the high voltage potential of the current lead to the ground potential of the environment. The main body of the current lead is that of a long cylinder, but at the cold termination and the cooling inlet, the local geometry is much more irregular. So the insulation wrapping and curing technology of the current lead had to be developed to acquire its uniform mechanical and electrical performance. Now, the multi-stage autoclave curing technology has been qualified in ASIPP and the series ITER current leads are being manufactured based on the qualified procedure. In this paper, the latest insulation progresses for the ITER current lead are introduced, the high voltage testing results as part of the formal qualification are presented and discussed.