Abstract:Following a decision made at the ITER Council in November 2013, two types of in-vessel coils (IVCs), namely, edge-localized mode (ELM) coils to mitigate ELMs and vertical stability (VS) coils to provide vertical stabilization of the plasma, have been incorporated in the ITER baseline design. The in-vessel environment is severe, characterized by large transient electromagnetic fields, high radiation flux, and high temperature. To withstand this environment and provide the required functionality, a "mineral insulated conductor" (MIC) technology has been selected for the IVC conductor. It consists of an axially water-cooled copper conductor surrounded by magnesium oxide insulation and a stainless steel jacket. A major advantage of the coil design is the choice of the same conductor material and dimensions for both VS and ELM coils, long conductor length which eliminates the need for any internal joints, and Cu welding for the joints between coils and feeders. In situ winding of the VS coils is asking for the development of a creative solution for the unspooling, straightening, precise winding tools, bending, forming, and metrology processes in a tight and congested environment. Mock-ups for design verification and manufacturing feasibility have been produced, in particular, for the bracket manufacture and to perform thermal and mechanical fatigue testing on an ELM control coil winding pack assembly. Installation trials of a half-size ELM control coil have been performed to verify the feasibility of the assembly procedure. This article will give an overview of the IVC design status and the progress of ITER IVC conductor manufacturing.

Operational experience with forced cooled superconducting magnets

The Electrical Insulation of Large Superconducting Magnets

Numerical Simulation of ITER PF1 Coil Heating at VPI of Electrical Insulation

Development Of Insulation Technology With Vacuum-Pressure-Impregnation (Vpi) For Iter Correction Coil

Results of Vacuum-Pressure Impregnation of the PF1 Coil Ground Insulation

Application of High Voltage Insulation on the Magnet Feeder Superconducting Joints during ITER Machine Assembly

Manufacturing and testing of high-strength low-temperature composite insulator

Completion and Factory Acceptance Test of ITER PF1 Coil

Dielectric insulation and high-voltage issues

Overview of verification tests on AC loss, contact resistance and mechanical properties of ITER conductors with transverse loading up to 30 000 cycles

Commissioning Tests of Tokamak JT-60SA (Chronicle)

Tryout of the vacuum impregnation procedure for the ITER PF1 coil on the VPI mold made of plastic shell

Experimental study on vacuum problem of conduction-cooled superconducting magnet system

Design and Testing of a Gas-Helium Conduction Cooled REBCO Magnet for a 300 kvar HTS Synchronous Condenser Prototype

Design of the Room Temperature Insulation Breaks for ITER Correction Coil Feeders

Mechanical and Thermal Characteristics of Insulation Materials for the KSTAR Magnet System at Cryogenic Temperature

Research on Insulation Technology for Nb3Sn Layer Coil of Superconducting Conductor Testing Facility

Mechanical Tests of the ITER's PF-1 Coil Electrical Insulation Qualification Samples at 77 K

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor