Abstract:Following a decision made at the ITER Council in November 2013, two types of in-vessel coils (IVCs), namely, edge-localized mode (ELM) coils to mitigate ELMs and vertical stability (VS) coils to provide vertical stabilization of the plasma, have been incorporated in the ITER baseline design. The in-vessel environment is severe, characterized by large transient electromagnetic fields, high radiation flux, and high temperature. To withstand this environment and provide the required functionality, a "mineral insulated conductor" (MIC) technology has been selected for the IVC conductor. It consists of an axially water-cooled copper conductor surrounded by magnesium oxide insulation and a stainless steel jacket. A major advantage of the coil design is the choice of the same conductor material and dimensions for both VS and ELM coils, long conductor length which eliminates the need for any internal joints, and Cu welding for the joints between coils and feeders. In situ winding of the VS coils is asking for the development of a creative solution for the unspooling, straightening, precise winding tools, bending, forming, and metrology processes in a tight and congested environment. Mock-ups for design verification and manufacturing feasibility have been produced, in particular, for the bracket manufacture and to perform thermal and mechanical fatigue testing on an ELM control coil winding pack assembly. Installation trials of a half-size ELM control coil have been performed to verify the feasibility of the assembly procedure. This article will give an overview of the IVC design status and the progress of ITER IVC conductor manufacturing.

Numerical Simulation of ITER PF1 Coil Heating at VPI of Electrical Insulation

Numerical Simulation of ITER PF1 Coil Heating at VPI of Electrical Insulation

Results of Vacuum-Pressure Impregnation of the PF1 Coil Ground Insulation

Mechanical Tests of the ITER's PF-1 Coil Electrical Insulation Qualification Samples at 77 K

Development Of Insulation Technology With Vacuum-Pressure-Impregnation (Vpi) For Iter Correction Coil

Tryout of the vacuum impregnation procedure for the ITER PF1 coil on the VPI mold made of plastic shell

R&D of Insulating and Vacuum Pressure Impregnation Equipment for PF1 Coil Double Pancakes

Completion and Factory Acceptance Test of ITER PF1 Coil

Operational experience with forced cooled superconducting magnets

Approaching ITER PF Coil Manufacturing

Assessment of ITER PF coil quality from magnetic measurements

Numerical assessment of geometrical and magnetic parameters for dummy double pancake of ITER PF1 coil using optic and magnetic measurements

Fatigue Behavior Testing and Evaluation of ITER In-vessel Mock-Up Coil under Combined Thermal and Electromagnetic Loads

Nondestructive Evaluation of Eccentricity of ITER In-Vessel Coils Based on Eddy Current Testing

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor

Application of High Voltage Insulation on the Magnet Feeder Superconducting Joints during ITER Machine Assembly

Development and Qualification of ITER Current Lead Electrical Insulation

Numerical Study on Thermal Stability of No-Insulation Coils Using a Three-Dimensional Finite-Element Model

Test of PF1 Coil Electrical Joint

Numerical simulation on the rollers' temperature of ITER PF compaction machine