Abstract:The ITER enhanced-heat-flux (EHF) FW fingers undertook by China are made by hot isostatic pressing (HIP) method to bond beryllium armor tiles to CuCrZr/316L(N) heat sinks with 10 mu m-thick Ti coating on beryllium tiles and 0.5 mm-thick oxygen free copper sheet as interlayer. To study its thermal fatigue behavior, small scale mock-up was manufactured with artificial defects (AD) on the beryllium tile surface with Ti coating. Thermal cycling of the mockup was carried out at 4.7 MW/m2 high heat flux (HHF) for 5000 cycles. The interface between Be/Ti/Cu and the fracture surface on beryllium tiles were observed by stereomicroscopy and scanning electron microscopy with energy spectrometer. The Be/Ti/Cu interfacial phase composition and the behaviors of defects after high heat flux test were analyzed. In addition, the generation and propagation mechanism of thermal fa-tigue defects were preliminarily studied in this paper. The results show that uniform bonding between Be and Cu was achieved and the interfacial phases are Be base/ Be-Ti intermediate/ alpha-Ti/ Ti2Cu/ TiCu /Cu base in the sequence. The formation of complex brittle phases reported in previous study, such as Ti3Cu4 or alpha-TiCu4, can be avoided by using Ti single interlayer. When the original defect dimension is only 3 x 3 mm2, the defect will not propagate after 5000 cycles 4.7 MW/m2 HHF testing (HHFT). Besides, decreasing beryllium tile size can reduce the possibility of thermal fatigue failure. In addition, from the research on fracture surface on beryllium tiles, the final fracture made for beryllium detachment mainly happened in Ti layer near the beryllium side. While thermal fatigue cracks preferentially originated at Be/Ti interface and the oxidation of beryllium surface under thermal cycling test would accelerate the generation and propagation of thermal fatigue defects.

Research and Analysis on Tensile and Compressive Fatigue Performance of Cryogenic Axial Insulation Breaks

High Temperature Baking Test and Study on Axial Insulation Breaks

Test research on performance of EAST composite axial insulation breaks

Microstructural analysis of the thermal fatigue tested Be/CuCrZr joint with artificial defects between Ti/Cu interlayers

Thermal fatigue failure behavior on Be/Cu joint of ITER first wall after enhanced heat flux test

Progress of High Heat Flux Component Manufacture and Heat Load Experiments in China

Design of the Room Temperature Insulation Breaks for ITER Correction Coil Feeders

Optimization Analysis on Electrical Insulation Performance of ITER Axial Composite Insulation Break

Performance research of the high quality helium tight composite insulators

The Structure Analysis of ITER Cryostat Based on the Finite Element Method

Manufacturing and testing of high-strength low-temperature composite insulator

Fatigue Behavior Testing and Evaluation of ITER In-vessel Mock-Up Coil under Combined Thermal and Electromagnetic Loads

Transient Analysis on Helium Coolant Tube Break Accident of Dual-Functional Lithium Lead Test Blanket Module

The Research on High-Strength CICC Jackets with YS > 1500 MPa at 4.2 K for Future Fusion Applications

Mechanical Test on the Iter Cc and Feeder Jacket

Experimental Investigation of the Mechanical Behavior of the Strain Isolation Pad in Thermal Protection Systems under Tension

Analysis of Interlaminar Fracture Toughness and the Mechanical Properties of Composite Cylinders

Thermal-mechanical combined damage analysis of 35kV dry-type air-core reactor inter-turn insulation

Mechanical test on the ITER TF jacket

Experimental study and theoretical analysis of ECC type I fatigue fracture after subjected to sub-high temperature

Mechanical Properties of ITER CICC Jacket in China