Abstract:Following a decision made at the ITER Council in November 2013, two types of in-vessel coils (IVCs), namely, edge-localized mode (ELM) coils to mitigate ELMs and vertical stability (VS) coils to provide vertical stabilization of the plasma, have been incorporated in the ITER baseline design. The in-vessel environment is severe, characterized by large transient electromagnetic fields, high radiation flux, and high temperature. To withstand this environment and provide the required functionality, a "mineral insulated conductor" (MIC) technology has been selected for the IVC conductor. It consists of an axially water-cooled copper conductor surrounded by magnesium oxide insulation and a stainless steel jacket. A major advantage of the coil design is the choice of the same conductor material and dimensions for both VS and ELM coils, long conductor length which eliminates the need for any internal joints, and Cu welding for the joints between coils and feeders. In situ winding of the VS coils is asking for the development of a creative solution for the unspooling, straightening, precise winding tools, bending, forming, and metrology processes in a tight and congested environment. Mock-ups for design verification and manufacturing feasibility have been produced, in particular, for the bracket manufacture and to perform thermal and mechanical fatigue testing on an ELM control coil winding pack assembly. Installation trials of a half-size ELM control coil have been performed to verify the feasibility of the assembly procedure. This article will give an overview of the IVC design status and the progress of ITER IVC conductor manufacturing.

Manufacture of EAST VS In-Vessel Coil

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor

Design Evolution and Integration of the ITER In-Vessel Components

Fabrication of the Toroidal Field Superconducting Coils for the EAST Device

Design and Development of Turn Insulation Automatic Wrapping System for CRAFT TF

Completion and Factory Acceptance Test of ITER PF1 Coil

The batch production for superconducting magnet coils of EAST (HT-7U)

Approaching ITER PF Coil Manufacturing

Development Of Insulation Technology With Vacuum-Pressure-Impregnation (Vpi) For Iter Correction Coil

Progress of the ITER Correction Coils in China

Manufacture and Behaviors of Superconducting Busbar Joint for ITER Correction Coil Feeder

Nondestructive Evaluation of Eccentricity of ITER In-Vessel Coils Based on Eddy Current Testing

Fully Active Cooled In-vessel Components of EAST Tokamak

Manufacturing of Iter Pf5 and Cc Sample Conductors

Manufacturing of the ITER TF Conductors in China

Developments of NDE Method of Jacket Welds for ITER In-Vessel Coil Joints

Preparation of the Manufacture of the ITER Correction Coils

Manufacturing Status of CFETR Central Solenoid Model Coil

Manufacturing and testing of high-strength low-temperature composite insulator

Fatigue Behavior Testing and Evaluation of ITER In-vessel Mock-Up Coil under Combined Thermal and Electromagnetic Loads

Mechanical Behavior of Superconducting Model Coil for International Thermonuclear Engineering Reactor (ITER) during Cool-down and Warm-up