Abstract:Following a decision made at the ITER Council in November 2013, two types of in-vessel coils (IVCs), namely, edge-localized mode (ELM) coils to mitigate ELMs and vertical stability (VS) coils to provide vertical stabilization of the plasma, have been incorporated in the ITER baseline design. The in-vessel environment is severe, characterized by large transient electromagnetic fields, high radiation flux, and high temperature. To withstand this environment and provide the required functionality, a "mineral insulated conductor" (MIC) technology has been selected for the IVC conductor. It consists of an axially water-cooled copper conductor surrounded by magnesium oxide insulation and a stainless steel jacket. A major advantage of the coil design is the choice of the same conductor material and dimensions for both VS and ELM coils, long conductor length which eliminates the need for any internal joints, and Cu welding for the joints between coils and feeders. In situ winding of the VS coils is asking for the development of a creative solution for the unspooling, straightening, precise winding tools, bending, forming, and metrology processes in a tight and congested environment. Mock-ups for design verification and manufacturing feasibility have been produced, in particular, for the bracket manufacture and to perform thermal and mechanical fatigue testing on an ELM control coil winding pack assembly. Installation trials of a half-size ELM control coil have been performed to verify the feasibility of the assembly procedure. This article will give an overview of the IVC design status and the progress of ITER IVC conductor manufacturing.

Nondestructive Evaluation of Eccentricity of ITER In-Vessel Coils Based on Eddy Current Testing

Nondestructive Evaluation of Eccentricity of Iter In-Vessel Coil Conductors Based on Pulsed Ect Method

Eddy Current Testing of Eccentricity in Tokamak In-Vessel Coil Conductors Based on Flexible Probe

Testing of Eccentricity in Tokamak In-vessel Coil Conductors

Eddy current test research for eccentricity of international thermonuclear experimental reactor (ITER) in-vessel coils (IVCs) conductor

Parameter Opitimization of Eddy Current Testing Probe for Evaluation of Eccentricity in Conductors of Tokamak In-Vessel Coils

Research on Nondestructive Examination of Bracket Welds of ITER In-Vessel Coils (IVC)

Fatigue Behavior Testing and Evaluation of ITER In-vessel Mock-Up Coil under Combined Thermal and Electromagnetic Loads

Developments of NDE Method of Jacket Welds for ITER In-Vessel Coil Joints

Final Design of ITER In-Vessel Coils and Manufacturing of In-Vessel Coil Conductor

A New Array Eddy Current Testing Probe for Inspection of Small-Diameter Tubes in Tokamak Fusion Devices

Developments of Nondestructive Test Method of Jacket Section for ITER Poloidal Field Coils

Development Of Insulation Technology With Vacuum-Pressure-Impregnation (Vpi) For Iter Correction Coil

Numerical Simulation of ITER PF1 Coil Heating at VPI of Electrical Insulation

Research on Nondestructive Examination of Jacket Section for CFETR TF Coil

Manufacture of EAST VS In-Vessel Coil

Proposal And Demonstration Of Strategies For Ndt Of Conduit Tube Of Cable In Conduit Conductors Used In Iter Pf Coils

Design of the Room Temperature Insulation Breaks for ITER Correction Coil Feeders

Immersed Ultrasonic Testing Methods for Conduit Tubes of ITER Superconducting Cables

From Design to Development Phase of the ITER Correction Coils