Abstract:The China Fusion Engineering Test Reactor (CFETR) is a new tokamak device whose magnet system includes toroidal field, central solenoid (CS) and poloidal field coils. The main goal is to build a fusion engineering tokamak reactor with about 1 GW fusion power and self-sufficiency by blanket. In order to reach this high performance, the magnet field target is 15 T. However, the huge electromagnetic load caused by high field and current is a threat for conductor degradation under cycling. The conductor with a short-twist-pitch (STP) design has large stiffness, which enables a significant performance improvement in view of load and thermal cycling. But the conductor with STP design has a remarkable disadvantage: it can easily cause severe strand indentation during cabling. The indentation can reduce the strand performance, especially under high load cycling. In order to overcome this disadvantage, a new design is proposed. The main characteristic of this new design is an updated layout in the triplet. The triplet is made of two Nb3Sn strands and one soft copper strand. The twist pitch of the two Nb3Sn strands is large and cabled first. The copper strand is then wound around the two superconducting strands (CWS) with a shorter twist pitch. The following cable stages layout and twist pitches are similar to the ITER CS conductor with STP design. One short conductor sample with a similar scale to the ITER CS was manufactured and tested with the Twente Cable Press to investigate the mechanical properties, AC loss and internal inspection by destructive examination. The results are compared to the STP conductor (ITER CS and CFETR CSMC) tests. The results show that the new conductor design has similar stiffness, but much lower strand indentation than the STP design. The new design shows potential for application in future fusion reactors.

Proposal And Demonstration Of Strategies For Ndt Of Conduit Tube Of Cable In Conduit Conductors Used In Iter Pf Coils

Immersed Ultrasonic Testing Methods for Conduit Tubes of ITER Superconducting Cables

Developments of Nondestructive Test Method of Jacket Section for ITER Poloidal Field Coils

Research on Nondestructive Examination of Jacket Section for CFETR TF Coil

A New Array Eddy Current Testing Probe for Inspection of Small-Diameter Tubes in Tokamak Fusion Devices

NDT Status of PF1 Coil Welds

Research on Nondestructive Examination of Bracket Welds of ITER In-Vessel Coils (IVC)

Non-destructive Examination on PF Butt Welds of ITER Superconducting Conductor

New Design of Cable-in-conduit Conductor for Application in Future Fusion Reactors

Identification Of Wire Breakage Status Based On The Measurement And Inversion Of Magnetic Field Aiming At Applications To Cable In Conduit Conductors Of Iter Magnets

Manufacturing of Iter Pf5 and Cc Sample Conductors

Research on Mechanical Properties of High-Performance Cable-in-conduit Conductors with Different Design

Developments of NDE Method of Jacket Welds for ITER In-Vessel Coil Joints

Performance Test and Analysis of the First Large-Scale Cable-in-conduit Conductor with High Jc Nb3Sn Strand for Fusion Reactor

A new enclosed method for transverse mechanical testing on CICC conductors

A Combined Inductive and Capacitive Non-Destructive Evaluation Technique Using a Single Spiral Coil Sensor

Eddy Current Testing of Eccentricity in Tokamak In-Vessel Coil Conductors Based on Flexible Probe

Research on Nondestructive Examination of Jacket Sections for CFETR Central Solenoid Model Coil

Optimization Of Cfetr Csmc Cabling Based On Numerical Modeling And Experiments

Nondestructive Evaluation of Eccentricity of ITER In-Vessel Coils Based on Eddy Current Testing

Evaluating Conductor Design and Stability Performance for the Conductor of High-Field Winding Package in CFETR TF Coil