Abstract:The China Fusion Engineering Test Reactor (CFETR) is a new tokamak device whose magnet system includes toroidal field, central solenoid (CS) and poloidal field coils. The main goal is to build a fusion engineering tokamak reactor with about 1 GW fusion power and self-sufficiency by blanket. In order to reach this high performance, the magnet field target is 15 T. However, the huge electromagnetic load caused by high field and current is a threat for conductor degradation under cycling. The conductor with a short-twist-pitch (STP) design has large stiffness, which enables a significant performance improvement in view of load and thermal cycling. But the conductor with STP design has a remarkable disadvantage: it can easily cause severe strand indentation during cabling. The indentation can reduce the strand performance, especially under high load cycling. In order to overcome this disadvantage, a new design is proposed. The main characteristic of this new design is an updated layout in the triplet. The triplet is made of two Nb3Sn strands and one soft copper strand. The twist pitch of the two Nb3Sn strands is large and cabled first. The copper strand is then wound around the two superconducting strands (CWS) with a shorter twist pitch. The following cable stages layout and twist pitches are similar to the ITER CS conductor with STP design. One short conductor sample with a similar scale to the ITER CS was manufactured and tested with the Twente Cable Press to investigate the mechanical properties, AC loss and internal inspection by destructive examination. The results are compared to the STP conductor (ITER CS and CFETR CSMC) tests. The results show that the new conductor design has similar stiffness, but much lower strand indentation than the STP design. The new design shows potential for application in future fusion reactors.

Manufacturing of Iter Pf5 and Cc Sample Conductors

Manufacturing of the ITER TF Conductors in China

Manufacture and Acceptance Test of the Full Size ITER PF5 Conductor Sample

Manufacture of ITER feeder sample conductors

Manufacturing of Nb3Sn Sample Conductor for CFETR Central Solenoid Model Coil

Manufacture and Performance Test Result of a 95 Ka-Class Nbti Cable-in-Conduit Conductor for the Low Field Winding-Package of Cfetr-Tf Coil

Approaching ITER PF Coil Manufacturing

Manufacture and Test of Bi-2212 Cable-In-Conduit Conductor

Summary of NbTi Strand Performance for ITER PF Conductors in China

Status Of The Iter Conductors In China

Performance Test and Analysis of the First Large-Scale Cable-in-conduit Conductor with High Jc Nb3Sn Strand for Fusion Reactor

New Design of Cable-in-conduit Conductor for Application in Future Fusion Reactors

Study on fabrication of ITER TF conductor

Stability Analysis on Nb3Sn Sample Conductor of CFETR Central Solenoid Model Coil

Research on Mechanical Properties of High-Performance Cable-in-conduit Conductors with Different Design

Evaluating Conductor Design and Stability Performance for the Conductor of High-Field Winding Package in CFETR TF Coil

Preparation of the Manufacture of the ITER Correction Coils

Conductor Performance of TFCN4 and TFCN5 Samples for ITER TF Coils

Manufacture and Test of a Prototype Nb3Sn-NbTi Joint Sample for the CFETR Central Solenoid Model Coil

From Design to Development Phase of the ITER Correction Coils