Abstract:Cryogenic deep reactive ion etching (Cryo DRIE) of silicon has become an enticing but challenging process utilized in front-end fabrication for the semiconductor industry. This method, compared to the Bosch process, yields vertical etch profiles with smoother sidewalls not subjected to scalloping, which are desired for many microelectromechanical systems (MEMS) applications. Smoother sidewalls enhance electrical contact by ensuring more conformal and uniform sidewall coverage, thereby increasing the effective contact area without altering contact dimensions. The versatility of the Cryo DRIE process allows for customization of the etch profiles by adjusting key process parameters such as table temperature, O2 percentage of the total gas flow rate (O2 + SF6), RF bias power, and process pressure. In this work, we undertake a comprehensive study of the effects of Cryo DRIE process parameters on the trench profiles in the structures used to define cantilevers in MEMS devices. Experiments were performed with an Oxford PlasmaPro 100 Estrelas ICP-RIE system using positive photoresist SPR-955 as a mask material. Our findings demonstrate significant influences on the sidewall angle, etch rate, and trench shape due to these parameter modifications. Varying the table temperature between -80°C and -120°C under a constant process pressure of 10 mTorr changes the etch rate from 3 to 4 μm/min, while sidewall angle changes by ~2°, from positive ( 90° relative to the Si surface) tapering. Altering the O2 flow rate with constant SF6 flow results in a notable 10° shift in sidewall tapering. Furthermore, SPR-955 photoresist masks provide selectivity of 46:1 with respect to Si and facilitates the fabrication of MEMS devices with precise dimension control ranging from 1 to 100 μm for etching depths up to 42 μm using Cryo DRIE. Understanding the influence of each parameter is crucial for optimizing MEMS device fabrication.

Performance comparison of methods to evading notching effect for SOG structures in DRIE

A Dual-Purpose Method to Enhance Heat Transfer and Prevent Notching Effect in Deep Reactive Ion Etching

Experimental Study on the Footing Effect for SOG Structures Using DRIE

Methods to Protect Silicon Microstructures from the Damages in Deep Reactive Ion Etching

Study of heat transfer on notching effect in DRIE

Isotropic Etch for SiO2 Microcantilever Release with ICP System

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

Improvement on the Uniformity of Deep Reactive Ion Etch for Electrically Isolated Silicon-Based Substrates

A method to reduce notching effect on the anchors of a micro-gyroscope

Discrimination of Dislocation in Highly Doped N-Type 4H-Sic by Combining Electrochemical Reaction and Molten Alkali Etching

An improved method to remove anti-footing Al layer after DRIE

Modeling and Simulation of Silicon Dry Etching

The Method of Prevent Footing Effect in Making SOI Micro-Mechanical Structure

Three-Dimensional Simulation of DRIE Process Based on the Narrow Band Level Set and Monte Carlo Method

Cryogenic DRIE Processes for High-Precision Silicon Etching in MEMS Applications

Test Structures and Drie Topography for Bulk Silicon Mems Devices

Fabrication of SOI MEMS Inertial Sensors with Dry Releasing Process

Method for Fabricating Micro/Nanostructures Via Scanning Probe Microscope and Anisotropic Wet Etching

P‐1.14: the Influence of Bottom Gate Dielectric Roughness on the Performance of Double‐Gate A‐igzo Thin Film Transistors

Electrochemical Impedance Spectroscopy for Quantitative Interface State Characterization of Planar and Nanostructured Semiconductor-Dielectric Interfaces