Abstract:This paper describes the improvement of advanced semi-additive processes (SAP) to demonstrate 1.5-5 μm lines and spaces with 4-5 μm diameter photo-vias for multiple re-distribution layers (RDL) at 20 μm bump pitch on glass interposers. High performance computing systems for networking and graphics are driving ultra-high bandwidth interconnections between logic and memory devices. This signal bandwidth need with lowest power consumption has enabled the application of 2.5D interposers for high density chip-to-chip interconnections. Silicon interposers with through-silicon-vias (TSVs) are capable of ultra-high density wiring between logic and memory chips, but use back end of line (BEOL) dual damascene processes, requiring chemical mechanical polishing (CMP), leading to high process cost, which limits their expansion into lower cost and higher volume applications. On the other hand, organic substrates processed on large panels have large capture pads for via landing due to their poor dimensional stability, limiting the bump pitch scaling at chip level. Glass interposers have been proposed to address the limitations of both silicon interposers and organic substrates in recent years. This paper reports on research to extend low cost and large panel semi-additive processes (SAP) to below 5um lines and vias. To achieve this, high resolution lithography processes combined with photosensitive dry film polymer dielectrics were optimized to form fine patterns and ultra-small micro-vias. A major challenge for multilayer RDL is the non co-planarity of copper electroplating, and a new cost-effective copper surface planarization process was proposed and evaluated for surface co-planarity improvement, leading to better yields for multi-layer RDL fabrication.

Optimization of Spin-on-glass Process for Multilevel Metal Interconnects

Optimization of Polysilicon Gate Etching Process in SONOS Memory Fabrication

Goi Improvement in 65nm Sacrificial Oxide Free Process Integration

Study of Silicon-on-glass Waveguides

Integrating The Soi And Poly-Si Surface Structures In A Monolithic Process For Optical Devices Platform

Investigation of the Reliability of the Interconnection between Metal Electrode and Silicon Anchor in Silicon-on-Glass Process

Integrating SOI and poly-Si surface structures using a monolithic process

A Wet Process to Form Silicon Oxide Thin Layer for Through Silicon Via Application

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

Optimization of Contact Interface Resistance for CMOS Circuits

A Low Temperature Silicon‐on‐Insulator Fabrication Process Using Si MBE on Double‐Layer Porous Silicon

Advances in Panel Scalable Planarization and High Throughput Differential Seed Layer Etching Processes for Multilayer RDL at 20 Micron I/O Pitch for 2.5D Glass Interposers

Recent Progress on Bumpless Cu/SiO2 Hybrid Bonding for 3D Heterogeneous Integration

Pillar-lattice-assisted stress-free silicon-on-insulator

Dose-Energy Match for the Formation of High-Integrity Buried Oxide Layers in Low-Dose Separation-By-Implantation-Of-Oxygen Materials

Optimization of Interlevel Dielectrics for Embedded Nonvolatile Deep Submicrometer Technologies

An SOI–MEMS Technology Using Substrate Layer and Bonded Glass As Wafer-Level Package

Liquid Metal Fluidic Connection and Floating Die Structure for Ultra Low Thermomechanical Stress of SiC Power Electronics Packaging

Design Technology Co-Optimization Strategy for Ge Fraction in SiGe Channel of SGOI FinFET

Low-Temperature Bonding And Interfacial Failure Behavior Of Si/Glass And Glass/Glass Chips

Analysis and Optimization of SDOI Structure to Maximize the Intrinsic Performance of Extremely Scaled MOSFETs