Abstract:SiO2 is one of the most widely used dielectric materials in optical and electronic devices. The Josephson voltage standard (JVS) chip fabrication process has rigorous requirements for the deposition temperature and step-coverage profiles of the SiO2 insulation layer. In this study, we deposited high-quality SiO2 insulation films at 60 °C using inductively coupled plasma-chemical vapor deposition (ICP-CVD) to fulfill these requirements and fabricate JVS chips simultaneously. SiO2 films have a high density, low compressive stress, and a sloped sidewall profile over the vertical junction steps. The sidewall profiles over the vertical junction steps can be adjusted by changing the radio frequency (RF) power, ICP power, and chamber pressure. The effects of sputtering etch and sloped step coverage were enhanced when the RF power was increased. The anisotropy ratio of the deposition rate between the sidewall and the bottom of the film was lower, and the sloped step coverage effect was enhanced when the ICP power was increased, or the deposition pressure was decreased. The effects of the RF power on the stress, density, roughness, and breakdown voltage of the SiO2 films were also investigated. Despite increased compressive stress with increasing RF power, the film stress was still low and within acceptable limits in the device. The films deposited under optimized conditions exhibited improved densities in the Fourier transform infrared spectra, buffered oxide etch rate, and breakdown voltage measurements compared with the films deposited without RF power. The roughness of the film also decreased. The step-coverage profile of the insulation layer prepared under optimized conditions was enhanced in the junction and bottom electrode regions; additionally, the performance of the device was optimized. This study holds immense significance for increasing the number of junctions in future devices.

Silicon Vertical Interconnect Technology of Low Cost

Electroless Plating Ni-based Barrier Layers for Silicon Vertical Interconnects

Towards 3-D Carbon-Based Heterogeneous Interconnects

A Wet Process to Fabricate Silicon Oxide Layer for Through-Silicon-via Insulator Application

A Wet Process to Form Silicon Oxide Thin Layer for Through Silicon Via Application

Copper electroplating technique for efficient manufacturing of low-cost silicon interposers

Research of Vertical via Based on Silicon, Ceramic and Glass

Vertical Assembly of Carbon Nanotubes for Vlsi Via Interconnection

Tungsten Through-Silicon Via Technology for Three-Dimensional LSIs

Through-silicon-via technology for 3D integration

Optimization of Spin-on-glass Process for Multilevel Metal Interconnects

Vertical Interconnections by Electroless Au Deposition on Electroless Ni Immersion Au Surface Finish

Fabrication and characterization of a low-cost interposer with an intact insulation layer and ultra-low TSV leakage current

An ultra-deep TSV technique enabled by the dual catalysis-based electroless plating of combined barrier and seed layers

Process Development of Thick Si Interposer for 2.5d Integration of Rf Mems Devices

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

Fabrication, Characterization, and Simulation of a Low-Cost TSV Integration Without Front-Side CMP Process

Fabrication and Characterization of Fine Pitch TSV Integration with Self-Aligned Backside Insulation Layer Opening.

Optimization of innovative approaches to the shortening of filling times in 3D integrated through-silicon vias (TSVs)

Low-Temperature Deposition of High-Quality SiO2 Films with a Sloped Sidewall Profile for Vertical Step Coverage

Organosiloxane nanolayer as diffusion barrier for Cu metallization on Si