Abstract:The atomic force microscope (AFM) can be used in dynamic tipping mode as an effective lithography technique capable of manufacturing nanometer sized devices on the surface of a silicon wafer with a higher resolution surface characterization. The most difficult challenge in fabrication of nanostructure based on AFM nano-oxidation approach is the way of controlling an electric field between a cantilever probe tip and a silicon wafer. A water bridge builds up between the tip and the wafer, resulting in the oxidation due to the high electric field in the region. A reconstructive AFM system for nano-oxidation with a tapping model, implemented in an air, was developed. The presented AFM implements the increasing of electric field intensity by analyzing the impact voltage from −1 V to −5 V, electric field, and ion concentrations at the ambient/oxide and oxide/silicon interfaces, while the growth of thin oxides assumes a single liquid/silicon interface, which is modeled as an infinitely long conducting plane. Therefore, particle distribution for the surface charge density is generated for topography simulations. Based on the control-parameters, an enhanced electrical field of up to 1010 V/m can be obtained, which provides a powerful support for controllable experimental study of nanostructures fabrication with AFM tip induced local anodic oxidation. This showed the dependence of applied voltage types and various nanostructures and life time of AFM tip, by controlling tip-sample position in nanolithography processes is an important factor for controlling the aspect electric field distribution. And the effect of different parameters on enhancement distribution was performed and analyzed in this paper.

The Method of Prevent Footing Effect in Making SOI Micro-Mechanical Structure

SOI Micro-Accelerometer Fabricated with Anti-Footing Technique

Ultra-high Precision Nano Additive Manufacturing of Metal Oxide Semiconductors Via Multi-Photon Lithography

Thin Layer Soi-Fets Used for Stress-Sensing and Its Application in Accelerometers

Fabrication of SOI MEMS Inertial Sensors with Dry Releasing Process

A single-mask dry-release process for fabrication of high aspect ratio SOI MEMS devices

Experimental Study on the Footing Effect for SOG Structures Using DRIE

A Dual-Purpose Method to Enhance Heat Transfer and Prevent Notching Effect in Deep Reactive Ion Etching

An improved method to remove anti-footing Al layer after DRIE

Design, fabrication and testing of a SOI accelerometer

AFM Tip-Based Fabrication of Silicon Nanostructures with Reduced Subsurface Amorphous Layers

Fabrication Challenges and Test Structures for High-Aspect-ratio SOI MEMS Devices with Refilled Electrical Isolation Trenches

Characterization of Residual Stress in SOI Wafers by Using MEMS Cantilever Beams

An SOI-based post-fabrication process for compliant MEMS devices

A Novel Fabrication Method for Flexible SOI Substrate Based on Trench Refilling with Polydimethylsiloxane

3-D finite element calculation of electric field enhancement for nanostructures fabrication mechanism on silicon surface with AFM tip induced local anodic oxidation

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

Performance comparison of methods to evading notching effect for SOG structures in DRIE

Pure Oxide Structure for Temperature Stabilization and Performance Enhancement of Cmos-Mems Accelerometer

Metal foundation construction to consolidate electroplated structures for successful removal of SU-8 mould