Abstract:The trigger voltage walk-in effect has been investigated by designing two different laterally diffused metal—oxide—semiconductor (LDMOS) transistors with an embedded silicon controlled rectifier (SCR). By inserting a P+ implant region along the outer and the inner boundary of the N+ region at the drain side of a conventional LDMOS transistor, we fabricate the LDMOS-SCR and the SCR-LDMOS devices with a different triggering order in a 0.5 μm bipolar-CMOS-DMOS process, respectively. First, we perform transmission line pulse (TLP) and DC-voltage degradation tests on the LDMOS-SCR. Results show that the trigger voltage walk-in effect can be attributed to the gate oxide trap generation and charge trapping. Then, we perform TLP tests on the SCR-LDMOS. Results indicate that the trigger voltage walk-in effect is remarkably reduced. In the SCR-LDMOS, the embedded SCR is triggered earlier than the LDMOS, and the ESD current is mainly discharged by the parasitic SCR structure. The electric potential between the drain and the gate decreases significantly after snapback, leading to decreased impact ionization rates and thus reduced trap generation and charge trapping. Finally, the above explanation of the different trigger voltage walk-in behavior in LDMOS-SCR and SCR-LDMOS devices is confirmed by TCAD simulation.

Negative Triggering Current Induced the Latch-up in the Circuit without the ESD device to Power

Trigger voltage walk-out phenomenon in SOI lateral insulated gate bipolar transistor under repetitive electrostatic discharge stresses

Investigation of the Trigger Voltage Walk-In Effect in Ldmos for High- Voltage Esd Protection

Trigger voltage walk-in effect of ESD protection device in HVCMOS

Substrate-engineered GGNMOS for low trigger voltage ESD in 65 nm CMOS process.

Static CMOS Latch-Up Considerations in HVIC Design

Effects of process variation on turn-on voltages of a multi-finger gate-coupled NMOS ESD protection device

Analysis of 65 Nm Technology Grounded-Gate NMOS for On-Chip ESD Protection Applications

Design Analysis of Novel Substrate-Triggered GGNMOS in 65nm CMOS Process

An Improved Ggnmos Triggered Scr for High Holding Voltage Esd Protection Applications

The Influence of an LIGBT on CMOS Latch Up in Power Integrated Circuit

Effects of Non-Fatal Electrostatic Discharge on the Threshold Voltage Degradation in Nano CMOS Devices

Design of a Novel Static-Triggered Power-Rail ESD Clamp Circuit in a 65-Nm CMOS Process

Substrate-Triggered Ggnmos in 65 Nm Cmos Process for Esd Application

An Investigation on Capacitance-Trigger ESD Protection Devices for High Voltage Integrated Circuits

A new 1200 V HVIC with high side edge trigger in order to solve the latch on failure by the negative VS surge

Area-efficient Transient Power-Rail Electrostatic Discharge Clamp Circuit with Mis-Triggering Immunity in a 65-Nm CMOS Process

Investigation on Bi-directional SCR ESD Protection Devices in a 0.18 μm RF CMOS Process

A Novel Substrate-Optimized GGNMOS for Low-Voltage ESD Protection in 65 nm CMOS Process

High-Holding-Voltage Silicon-Controlled Rectifier for ESD Applications

Low Power, and Highly Reliable Single Event Upset Immune Latch for Nanoscale CMOS Technologies