Abstract:Microlens arrays (MLAs) made from fused silica possess broad applications in wavefront sensing, optical focusing, beam shaping, etc. However, it is challenging to fabricate the hard-brittle silica MLAs with high accuracy and low cost by conventional manufacturing techniques efficiently. In this work, a novel two-step method, which consists of rapid evaporative ablation and precision melting polishing by CO2 lasers, is proposed to fabricate high-quality MLAs. The first step is to rapidly ablate and engrave micro-pillar arrays (MPAs) with flat groove bottom by high-energy density CO2 lasers. The second step is to precisely polish and shape the flat-topped MPAs into the dome-topped MLAs with good surface roughness (Sa) by low-energy density CO2 lasers. The whole preparation process could be achieved through a set of machining system. Firstly, the geometric dimension (period, p and height, h) of the microlens is determined by the Monte Carlo ray tracing method. Secondly, to diminish the groove depth inconsistency caused by heat accumulation, the multiple ablation compensation strategy is developed. The MPAs (p = 200-400 mu m), of which maximum height error is 7.1%, are prepared in 1 s by the proposed compensation strategy. Then, the MPAs are smoothed into the MLAs by lowenergy density CO2 lasers, and the average Sa is improved from 960 nm to 32.56 nm. Finally, the optical performances of the MLAs are verified from the effectiveness of imaging, focusing and homogenization. The proposed two-step processing method paves a new way to fabricate high-performance MLAs on hard-brittle fused silica with low cost and high efficiency.

Fabrication of Ultra-High Q Silica Microdisk Using Chemo-Mechanical Polishing

Ultra-high-Q Microcavities Fabricated on Fused Silica Chips by Three-Dimensional Femtosecond Laser Microfabrication

Fabrication of Optical Cavities with Femtosecond Laser Pulses

A New Route for Fabricating Polymer Optical Microcavities.

Dry-etched Ultrahigh-Q Silica Microdisk Resonators on a Silicon Chip

High-Q and highly reproducible microdisks and microlasers.

Fabrication of Ultra-High-q Ta2O5 Microdisks by Photolithography-Assisted Chemo-Mechanical Etching

Demonstration of High-Performance, Sub-Micron Chalcogenide Glass Photonic Devices by Thermal Nanoimprint

Focused ion beam polishing based optimization of high-Q silica microdisk resonators

Ultrahigh-Q crystalline microresonator fabrication with only precision machining

Achieving Ultralow Surface Roughness and High Material Removal Rate in Fused Silica Via a Novel Acid SiO2 Slurry and Its Chemical-Mechanical Polishing Mechanism

Research on Silica Microdisk by Wet-etching

Fabrication of SiO2 Microdisk Optical Resonator

Chip‐Scale Mass Manufacturable High‐Q Silicon Microdisks

Fabrication and characterization of on-chip silicon spherical-like microcavities with high Q-factors

High-Q Silica Microdisk Optical Resonators with Large Wedge Angles on a Silicon Chip

High-Performance Whispering Gallery Microcavities Fabricated by Direct Laser Writing

Fabrication of High-Quality Microlens Arrays on Fused Silica Based on Combined Rapid Evaporative Ablation and Precision Melting Polishing of CO2 Lasers

Silica-based microcavity fabricated by wet etching

Atomic-scale surface of fused silica induced by chemical mechanical polishing with controlled size spherical ceria abrasives

Hydrophobic Silica Microcavities with Sustainable Nonlinear Photonic Performance