Abstract:Cr2AlB2 and Cr4AlB4 are members of the MAB phases that exhibit unique properties of both metals and ceramics. However, despite these unique characteristics, Cr2AlB2 and Cr4AlB4 phase coatings have not been widely investigated. In this study, Cr2AlB2 and Cr4AlB4 MAB phase coatings were fabricated by magnetron sputtering at room temperature and post-annealing. A composite target, consisting of a phase-pure disc-shaped CrB target overlapped by uniformly dispersed fan-shaped Al slices, was placed parallel to the substrates. The Al content of the coatings was adjusted by altering the areal proportion of the Al slices. MAB phases have crystallized upon post-annealing the as-deposited coatings on Al2O3(0001) substrates in Ar. The phase compositions and morphologies of the crystalline coatings were found to be dependent on the Al content and the annealing temperature. As-deposited coatings with a Cr:Al:B ratio close to 2:1:2 could crystallize as pure and dense Cr2AlB2 phases within the temperature range of 650–800 °C; higher annealing temperatures resulted in the decomposition of Cr2AlB2, while crystallization at lower temperatures was not evident from X-ray diffraction. As-deposited coatings with a Cr:Al:B ratio close to 3:1:3, despite containing a relatively higher Al content than required by the stoichiometry of Cr4AlB4, exhibited insufficient crystallization of Cr4AlB4 with unknown phases below 840 °C. Higher annealing temperatures resulted in the coexistence of Cr4AlB4 and CrB, indicating that achieving phase-pure and well-crystallized Cr4AlB4 coatings proved challenging, possibly due to the inevitable loss of Al during annealing. The configuration of the composite target and the substrates provides a promising strategy for fabricating phase-pure and dense Cr2AlB2 coatings.

Molten salt synthesis of orthorhombic CrB and Cr2AlB2 ceramics

Ternary-layered Cr2AlB2 synthesized from Cr, Al, and B powders by a molten salt-assisted method

Synthesis of Nano Sized Cr2AlC Powders by Molten Salt Method

Synthesis of zirconium boride (ZrB2) rod crystals through salt-assisted boro/carbothermal reduction

Synthesis and characterization of submicro-sized V2AlC ceramics by a two-step modified molten salt method

Effects of Doped Elements (Si, Cr, W and Nb) on the Stability, Mechanical Properties and Electronic Structures of MoAlB Phase by the First-Principles Calculation

Phase Pure and Well Crystalline Cr2AlB2: A Key Precursor for Two-Dimensional CrB

Synthesis of Aluminium Borate Nanowires by Sol–gel Method

Effects of boron content on the structure and magnetic properties of Fe81-xSi13BxMo2Cr1Cu1P2 nanocrystalline alloys

In-situ Synthesis of Nanocrystalline TiC Powders, Nanorods, and Nanosheets in Molten Salt by Disproportionation Reaction of Ti(II) Species

Synthesis and Research of the Phase Formation of Solid Solutions of Bismuth Chromates in the Triple Systems MeO–Cr2O3–Bi2O3 (Me = Sr, Ca)

Molten Salt Synthesis of Bismuth Ferrite Nano‐ and Microcrystals and Their Structural Characterization

Molten-salt Synthesis of BaTiO3 Powders and Their Atomic-Scale Structural Characterization

Key to Enhance Thermoelectric Performance by Controlling Crystal Size of Strontium Titanate

Fabrication of Cr2AlB2 and Cr4AlB4 MAB Phase Coatings by Magnetron Sputtering and Post-Annealing

Microstructure and Dielectric Properties of Strontium Bismuth Niobium Ceramics Prepared by Molten Salt Method

Exploration of an atomic‐scale boron additive in SiAlON ceramics

Synthesis, microstructural characterization, and dielectric properties of BiFeO3 microcrystals derived from molten salt method

Synthesis of Pure Bi<sub>12</sub>SiO<sub>20</sub> Powder by Molten Salt Method

Preparation of ultrafine (W,Mo)B, (W,Mo)B2.5 and (Mo,W)AlB solid solution composite powders

Integrating preparation of borides and separation of alkaline- and rare-earth ions through an electrochemical alloying approach in molten salts