Abstract:Atmospheric-pressure (AP) plasma sources have attracted researchers in many engineering fields, due to its low cost and easy handling. The AP plasma technique has been successfully applied on the surface figuring and texturing of Si, fused silica, RS-SiC, and SiC, etc. However, these studies focus more on better control for surface figuring of the substrate. The understanding of how the Si surface roughening or smoothing is occurred during the AP plasma etching using He-based CF4 mixture gas has seldom been reported. The present study starts from a parametric study of O2 addition concentration to He-based CF4 plasma. A groove is initially etched on a single-crystal silicon wafer by the CCP-type parallel-plate plasma etcher, to study the etching rate, surface morphology, material removal characteristics, and surface roughness evolution after the plasma etched removal. It is revealed that the material removal with a typical profile is achieved without introducing further damage. At the same time, the surface finish and surface integrity were enhanced by the AP plasma. The underlying mechanism of the process was investigated. Additionally, the optimized gas composition is then applied to the larger area etching by the computer-controlled scanning with different feed rates. Based on the experimental results, the surface evolution during the plasma etching process is revealed in detail. The surface removal profile also demonstrates that this method can provide an alternative way to achieve damage-free material removal for a larger area substrate by the duplicating of the typical removal profile with different etching path.

Investigation on surface smoothing of silicon-on-insulator with gas phase hydrogen chloride etching

Hydrogen etching of 4H–SiC(0001) facet and step formation

Optimization of Metal-Assisted Etchant Components for Fabrication of Porous Silicon

Research on Silicon Wafer Surface Phase under the Ultra-thin Slicing Process and Its Etching Hindrance Behavior during Metal-Assisted Chemical Etching

Simple Smoothing of the Bottom Silicon Surface Using Wet Chemical Etching Methods for Epitaxial III‐V/Silicon Tandem Manufacturing

Smooth and Vertical Etching of GaAs/GaInP/AlGaInP Using Inductively Coupled Cl2/BCl3/CH4 Plasma

Achievement of a near-perfect smooth silicon surface

Formation of ultralow-reflectance silicon surface by dry etching

Study of Anisotropic Etching of (100) Si with Ultrasonic Agitation

Study of the Nanometer Scale Polysilicon Micro Structure Etching

A Combined Etching Process Toward Robust Superhydrophobic Sic Surfaces

Towards Investigating Surface Quality of Single-Crystal Silicon Optics Polished with Different Processes

A study on the etching characteristics of atmospheric pressure plasma for single-crystal silicon wafer

Interface Investigation on SiGe/Si Multilayer Structures: Influence of Different Epitaxial Process Conditions

Research on Surface Topography of Silicon Wafer in Chemical-mechanical Polishing

Dry Etching Characteristics of Algan/Gan Heterostructures Using Inductively Coupled H-2/Cl-2, Ar/Cl-2 and Bcl3/Cl-2 Plasmas

Influence of Growth Process on Suppression of Surface Morphological Defects in 4H-SiC Homoepitaxial Layers

Effect of tetramethylammonium hydroxide/isopropyl alcohol wet etching on geometry and surface roughness of silicon nanowires fabricated by AFM lithography

Detailed Study of SiOxNy:H/Si Interface Properties for High Quality Surface Passivation of Crystalline Silicon

Atomic layer etching of SiO$_2$ using sequential exposures of Al(CH$_3$)$_3$ and H$_2$/SF$_6$ plasma

Investigation on the initial growth of nanocrystalline silicon prepared from hydrogen-diluted SiCl<sub>4</sub> at low temperatures