Abstract:Quartz is a widely used material in the field of microelectromechanical systems (MEMS) for fabricating devices such as substrates, probes, and lenses; it is also indispensable as a resonator or oscillator for frequency control in communication and network technologies. However, its development is limited because it is difficult to fabricate an ideal profile for implementation in complex structures. In practice, wet etching is the most effective and extensive method for achieving the expected structure, although dry etching and other special machining techniques have also been investigated. In this study, the dynamic wet etching process was recorded using different ratios of buffered oxide etcher (BOE) solutions as the etchant to reveal the etching mechanism. The experiments were first designed considering the fabrication of samples, experimental conditions, and measurement indicators. Subsequently, the corresponding etch rate, roughness, and surface morphology were investigated to control the process parameters during wet etching. Different etchants exhibit varying etching rates and roughness properties. A smaller proportion of hydrofluoric acid in the BOE solution results in lower etch rate, and vice versa. The roughness (Ra) in the stable stage was not completely consistent with the tendency of the etch rate, whereas the surface morphology and dimensions of the pyramids rationally complied with the roughness trend. Additionally, the results suggested that the three following stages exist during the wet etching process of the z-cut α-quartz wafer; smooth, incremental, and stable. The analysis of the dynamic wet etching process in this study is beneficial for the structural design, manufacturing, and performance of quartz MEMS devices.

A Two-step Wet Etching Process of PZT Thin Film With Ultra-low Undercut for MEMS Applications

Study on Wet-etching of PZT Thin Films

A Novel Wet Etching Process of Pb(Zr,Ti)O-3 Thin Films for Applications in Microelectromechanical System

A One-step Residue-free Wet Etching Process of Ceramic PZT for Piezoelectric Transducers.

An Efficient and Noticeable Wet Etching Method for PZT and Its Application in Scanning Mirrors

Study on Wet-Etching of PZT Thin Film

Research of Spray Etching of PZT Film

Spray Wet Etching Process for Preparing PZT Thick-Film

Preparation of A High-Quality Pzt Thick Film with Performance Comparable to Those of Bulk Materials for Applications in Mems

Effect of Wet Etching on Properties of Lead Zirconium Titanate During Integration Process

Dynamic Process of Wet Etching Using BOE Solutions to Control the Etch Rate, Roughness, and Surface Morphology of a Z-cut Α-Quartz Wafer

Eroding of Lead Zirconate Titanate (PZT) Thin Films

Preparation and characterization of lead zirconate titanate thick films prepared by chemical solution deposition for MEMS applications

Fabrication of PZT microdevices using a high-yield sol-gel process

Advances of PZT Ferroelectric Thin Films in Etching Techniques

Patterning PZT Thin Films using Reactive Ion Beam Etching for PiezoMEMS, RF MEMS Resonator and Filter Applications

Study on Wet-etching of ITO Thin Films Based on PLZT

Effective Approaches to Improve Au Etching Process Performance in MEMS Devices

High Quality PZT Thick Films Using Silicon Mold Technique for MEMS Applications

Magnetically Enhanced Reactive Ion Etching of Lead Zirconate Titanate Thin Film by CHF3 Plasma

Low Thermal Budget Lead Zirconate Titanate Thick Films Integrated on Si for Piezo-Mems Applications