Abstract:The physical properties of metal-based structural materials, such as hardness, strength and toughness, are directly or indirectly affected by residual stress inside or on the surface of the given part. Repeated rapid heating and cooling during the additive manufacturing process causes thermal gradients and expansion and contraction in the material, which causes residual stress. Tensile residual stresses are known to exist on the surface of additive manufactured products and should be kept to a minimum as they affect the mechanical properties and lead to product deformation and product failure. Therefore, it is important to evaluate the residual stress after making the product and to control it under the desired conditions. There are limitations to using the destructive method commonly used for residual stress evaluation with additive manufacturing products, due to difficulties in repeated measurements, product size, and cost issues. Therefore, it is necessary to apply a non-destructive evaluation method and verify the validity of the method. In this study, A356.2 aluminum alloy powders were used for additive manufacturing using the powder bed fusion process, and the surface residual stress generated during the process was measured. X-ray diffraction (XRD) methods were used to observe the surface residual stress. After XRD measurement, analyses were performed using the Williamson-Hall plot, sin 2 ψ, and cosα methods. The residual stress measurement results of samples manufactured through the LPBF process and the characteristics and limitations of each method were discussed.

Residual Stress of Individual Aluminum Grains from Three Dimensional X-Ray Diffraction

X-Ray Computer Tomography on Residual Stress Measurement

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview

X-Ray Residual Stress Measurement in Films with Crystallographic Texture and Grain Shape

Stress analysis of polycrystalline thin films and surface regions by X-ray diffraction

Residual Stress Analysis of Additive Manufactured A356.2 Aluminum Alloys using X-Ray Diffraction Methods

Diffraction-Based Multiscale Residual Strain Measurements

A Study On Residual Stress Distribution Measurement Of Dual Phase Stainless Steel By Means Of X-Ray Method

A Deconvolution Method for the Mapping of Residual Stresses by X-Ray Diffraction

Local Residual Stress in Partially Recrystallized Iron Characterized Using High Resolution Electron Backscatter Diffraction

Investigation of the Deformation Structure in an Aluminium Magnesium Alloy by High Angular Resolution Three-Dimensional X-Ray Diffraction

Test Method for Residual Stress Analysis of the Inner Surface of Small Caliber Ti-3Al-2.5V Tubing by X-ray Diffraction

Measurement of stress using synchrotron x-rays.

On the Surface Residual Stress Measurement in Magnesium Alloys Using X-Ray Diffraction

Neutron diffraction methods for the study of residual stress fields

Evaluation of Residual Stress in Fiber-Textured Films by X-Ray Diffraction

A Novel X-ray Diffraction Procedure for Determining Residual Stresses Around Cold Expanded Holes

A study of stress, composition and grain interaction gradients in energy‐dispersive X‐ray stress analysis on materials with cubic symmetry

X-Ray Measurement for Residual Stress in Cold Ring Rolling

Effect of Peak Positioning Method on Accuracy of X-Ray Diffraction Residual Stress Measurement