Abstract:Current experimental and numerical quantification methods are limited in their ability to full-field mapping of the unpredictable distribution of all residual stress and permanent plastic strain components in additive manufacturing parts with discontinuous processing properties. To address this limitation, a tomographic eigenstrain (inherent strain) reconstruction method, that merges eigenstrain reconstruction with diffraction strain tomography for mapping volumetric distribution of all components of eigenstrains and corresponding elastic deformations like residual stresses non-destructively using minimum amount of tomographic scans is presented through numerical experiments, and then applied to the analysis of a CM 247 LC superalloy additive manufacturing part using diffraction strain tomography data. The method reconstructs all eigenstrain and corresponding residual stress components, parallel to the build direction, aligned with the experimental data component accurately, demonstrating its potential in optimizing the performance and reliability of parts designed for high-tech industries such as aerospace. Subsequent validations using the X-ray diffraction sin 2 ψ and neutron diffraction strain scanning techniques confirm the method's reliability in reconstructing residual stress components parallel to the plane of powder bed that are different from the experimental data component. Furthermore, the novel findings of this study reveal a characteristic residual stress distribution pattern within additive manufacturing parts particularly those featuring rectangular shapes. Microstructural analysis also validates eigenstrain distribution in accordance with the findings on the characteristic distribution of residual stresses, highlighting the significance of this method in advancing materials research and development.

A Deconvolution Method for the Mapping of Residual Stresses by X-Ray Diffraction

X-Ray Computer Tomography on Residual Stress Measurement

Method to Analyze and Evaluate the Depth Profile of the Three Dimensional Residual Stresses State with X-ray

THE-STATE-OF-THE-ART OF THE STUDY ON RESIDUAL STRESS MEASUREMENT BY X-RAY ANALYSIS

Research on X-Ray Computer Tomography for Measuring Residual Stresses of Beryllium Weldment

X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview

Residual Stress of Individual Aluminum Grains from Three Dimensional X-Ray Diffraction

Tomographic eigenstrain reconstruction for full-field residual stress analysis in large scale additive manufacturing parts

Residual stress determination by the layer removal and X-ray diffraction measurement – correction method

A New Residual Strain Mapping Program Using Energy Dispersive X-Ray Diffraction at the Advanced Photon Source

Neutron diffraction methods for the study of residual stress fields

Diffraction-Based Multiscale Residual Strain Measurements

The Principle of Strain Reconstruction Tomography: Determination of Quench Strain Distribution from Diffraction Measurements

Mapping stress heterogeneity in single-crystal superalloys by novel submicron-resolved X-ray diffraction

A Simple Calibration Method to Consider Plastic Deformation Influence on X-ray Elastic Constant Based on Peak Width Variation

Uncertainty in flow stress measurements using X-ray diffraction for sheet metals subjected to large plastic deformations

Stress analysis of polycrystalline thin films and surface regions by X-ray diffraction

A comparison of X-ray stress measurement methods \\based on the fundamental equation

Imposing equilibrium on measured 3-D stress fields using Hodge decomposition and FFT-based optimization

Computationally efficient stress reconstruction from full-field strain measurements

A Novel X-ray Diffraction Procedure for Determining Residual Stresses Around Cold Expanded Holes