Abstract:Reactive ion beam etching of silicon is performed at low substrate temperature (153<T<300 K). The beam is extracted from a SF6 microwave plasma. The energy of the beam is 100 eV<E<400 eV, the ion current density is 0<J<5 mA cm−2. Energy distribution and composition of the beam have been studied using a mass spectrometer coupled with a cylindric mirror analyzer. The beam can be considered as monoenergetic with a full width at half-maximum about 8 eV. Using SF6 plasma, F+ is the predominant species, a significant proportion of SF+, SF2+, S+, and SF3+ ions is present in the beam. The active neutral flux of fluorine atoms coming from the ion source has been estimated between 6×1016 and 4×1017 cm−2 s−1. When no ion beam strikes the sample, the probability of reaction of neutral F atoms with Si is evaluated between 0.02 and 0.1 at 300 K. The decrease of the substrate temperature has revealed the role of the ion-induced reaction and the ion-stimulated desorption of SFx radicals in the etching process. At relative low power densities (100<E<400 eV and J=0.65 mA cm−2), an increase in the etch yield occurs as the temperature decreases until 220 K because there is an enhancement of the ion-induced reactions. If the energy of the beam is not high enough, the etching is reduced or even blocked by a thick layer of adsorbed molecules at T<220 K. At higher power densities (100<E<400 eV and 2 mA cm−2<J<5 mA cm−2) no significant etch yield enhancement is noted as the temperature decreases because the ion-stimulated desorption becomes predominant. In the case of high current density which corresponds to low values of the ratio of neutral flux over ion flux (a few ten), the etch yield approaches the value of the physical sputtering yield calculated by a model derived from the Sigmund cascade collision.

Etching of glass, silicon, and silicon dioxide using negative ionic liquid ion sources

Traceless Mitigation of Laser Damage Precursors on a Fused Silica Surface by Combining Reactive Ion Beam Etching with Dynamic Chemical Etching

Isotropic Etch for SiO2 Microcantilever Release with ICP System

Characteristics of Several Common Optical Materials in Ion Beam Etching

Ion beam lithography with gold and silicon ions

Anisotropic Ion Beam Etching Of Fused Silica To Mitigate Subsurface Damage

Low-damage etching of poly-Si and SiO 2 via a low-energy electron beam in inductively coupled CF 4 plasma

A 16 Cm Broad-Beam Ion Source For Ion-Beam Etching Of Quartz Wafers

Ion microscopy based on laser-cooled cesium atoms

An ion beam processing technology for complex component glass

Etching of Si at low temperatures using a SF6 reactive ion beam: Effect of the ion energy and current density

Development of an Ionic-liquid Ion Beam Source for Secondary Ion Mass Spectrometry (SIMS)

Silicon Wafer Etching by Transmitted Electron‐Beam‐Enhanced Plasma

Effect of ion beam etching on surface/subsurface structural defect evolution in fused silica optics

Synchrotron-Radiation-Excited Etching Of Silicon Wafer Enhanced By Disk-Shaped Cf4 Plasma

Removal of Antireflection Sol-Gel SiO2 Coating Based on Ar Ion Beam Etching

Polyatomic ions from a high current ion implanter driven by a liquid metal ion source

Sub-damage-threshold plasma etching and profile tailoring of Si through laser-stimulated thermal desorption

Controlling the Low-temperature Ionic Purification of a Silicon Surface by Electron Spectroscopy

Experimental Studies on the Acceleration of Positive & Negative Ions with a Heavy Ion ISR RFQ

Bright focused ion beam sources based on laser-cooled atoms