Abstract:Revealing the regularities of interaction of accelerated ions with an irradiated material based on the Monte Carlo simulation contributes to the efficient application of focused ion beam technique in modern nanotechnologies. The correctness of the calculation results depends on the model chosen and the parameters determining the surface binding energy (SBE) of sputtered atoms. In this work, the SBE has been determined within the discrete–continuous model, which makes it possible to consider the formation of gallium precipitates during irradiation of a silicon substrate with gallium ions. To compare the simulation results with the experimental data on material sputtering by a focused ion beam, two types of rectangular boxes have been prepared. The structures of the first type were formed at the same dose, close to 5 × 10 17 cm –2 (corresponding to the steady-state sputtering regime), at accelerating voltages of 8, 16, and 30 kV. The structures of the second type were formed at an ion energy of 30 keV and doses of 2.5 × 10 16 , 5 × 10 16 , and 1 × 10 17 cm –2 . The box cross sections were investigated by transmission electron microscopy. The sputtering yield and depth distribution profiles of gallium atoms, calculated in the SDTrimSP 5.07 software package, were compared with the experimental data using the R factor. Two sets of values have been established for the variable parameters: the SBE of gallium atoms and the α 1 parameter of the discrete–continuous model. The first set describes the experimental data with acceptable accuracy for a small number of implanted gallium atoms, which is implemented for low ion doses, as well as for a beam energy of 8 keV and a dose of 5 × 10 17 cm –2 . The second set is optimal for describing the ion beam interaction with the substrate at ion energies of 16 and 30 keV under steady sputtering conditions.

Ion beam lithography with gold and silicon ions

Simulations of the parameters in the focused ion beam implanted different materials

Focused Ion Beam Assisted Interface Detection for Fabricating Functional Plasmonic Nanostructures

Direct Writing Techniques in Microfabrication Using Focused Ion Beams

Focused helium ion beam nanofabrication by near-surface swelling

Fabrication Of Suspended Periodic Nanostructure By Focused Ion Beam Induced Material Migration And Rayleigh-Plateau Instability

Focused Ion Beam Built-Up on Scanning Electron Microscopy with Increased Milling Precision

Large-Area and High-Precision Milling of Focused Ion Beam Based on the Integration of Nanoscale Machine Vision and Compensation Control

Measurement and Simulation of Ultra-Low-Energy Ion-Solid Interaction Dynamics

Nanostructuring Optical Waveguides by Focused Ion Beam Milling. Near-Field Characterization

Gold Nanoparticle Patterning of Silicon Wafers Using Chemical E-Beam Lithography.

Patterning of Fine Features on Material Surfaces Using a Ga Ion-Beam in a FIB-SEM

Focused-ion-beam stress introducing technology for micro/nano-fabrications

Creating nanostructures on silicon using ion blistering and electron beam lithography

Ion beam induced enhanced diffusion from gold thin films in silicon

Versatile Approach of Silicon Nanofabrication without Resists: Helium Ion-Bombardment Enhanced Etching

Simulation of Material Sputtering and Gallium Implantation during Focused Ion Beam Irradiation of a Silicon Substrate

3‐D Nanofabrication of Silicon and Nanostructure Fine‐Tuning via Helium Ion Implantation (Adv. Mater. Interfaces 10/2022)

Direct writing of gold nanostructures with an electron beam: On the way to pure nanostructures by combining optimized deposition with oxygen-plasma treatment

Investigation on Etch Performance of Focused Ion Beam

Nanoscale 3D tomography by in-flight fluorescence spectroscopy of atoms sputtered by a focused ion beam