Abstract:To ascertain the influence of SiC nanowires on sintering kinetics of heterophase ceramics, two composite powders (TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire) are fabricated by mechanically activated combustion synthesis of Ta-Si-C and Ta-Si-C-(C2F4) reactive mixtures. Remarkable compressibility is achieved for the TaSi2-TaC-SiC-SiCnanowire composition (green density up to 84% as compared with 45.2% achieved for TaSi2-SiC-TaC) which is attributed to the lubricating effect of residual adsorbed fluorinated carbon (most likely C4F8). The outcomes of pressureless sintering of TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire compositions are vastly different; the former experiences no significant densification or grain growth and does not attain structural integrity, whereas the latter achieves relative density up to 93% and hardness up to 11 GPa. The SiC nanowires are not retained in consolidated ceramics, but instead, act as a sintering aid and promote densification and grain growth. Sintering mechanisms of TaSi2-TaC-SiC and TaSi2-TaC-SiC-SiCnanowire powders are analyzed using thermodynamic and ab initio grand potential calculations, as well as the analysis of grain size versus relative density relations. In the case of solid-state sintering, the densification and grain growth in heterophase non-oxide ceramics are governed by the same mechanisms as previously investigated single-phase oxides. The presence of SiC nanowires enhances grain-boundary related diffusion processes due to the high specific surface and aspect ratio of the nanowires. At 1500 °C, where the formation of the transient Si-based liquid phase is thermodynamically viable, only the SiC nanowire-containing composition demonstrated the intense grain coarsening and densification associated with liquid-assisted sintering. This effect can be attributed both to the presence of SiC nanowires and purification of residual oxide impurities due to C2F4-activated combustion synthesis employed for the in situ formation of SiC nanowires.

Effect of nitride addition on the electrical and thermal properties of pressureless solid-state sintered SiC ceramics

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Pressureless solid-state sintering of SiC ceramics with BN and C additives

Deposition and Thermoelectric Properties of N-Doped SiC Thick Films

Effects of boron source on properties of pressureless solid-state sintered silicon carbide ceramics

Fabrication of high thermal conductivity silicon nitride ceramics by pressureless sintering with MgO and Y2O3 as sintering additives

Electrical properties of SiC-AlN ceramics pressureless sintered under N2 atmosphere

Effects of Sintering Additives on the Thermoelectric Properties of SiC Ceramics

Effect of In Situ Grown SiC Nanowires on the Pressureless Sintering of Heterophase Ceramics TaSi2-TaC-SiC

High Thermal Conductivity in Pressureless Densified SiC Ceramics with Ultra-Low Contents of Additives Derived from Novel Boron–carbon Sources

Effect Of Rare-Earth Additives On Thermal Conductivity, Mechanical And Electrical Properties Of Silicon Nitride Ceramics

Effects of AlN Content and Sintering Atmospheres on the Thermal Conductivity of Hot-Pressed SiC Ceramics

Enhanced mechanical properties of R–SiC honeycomb ceramics with in situ AlN–SiC solid solution

Synergetic enhancement of electrical conductivity and infrared emissivity of SiC-MoSi2 ceramics via N doping

Dielectric constant, dielectric loss and thermal conductivity of Si3N4 ceramics by hot pressing with CeO2–MgO as sintering aid

Effect of Post-Sintering Heat-Treatment on Thermal Conductivity of Si3N4 Ceramics Containing Different Additives

Fabrication of Si3N4 ceramics with improved thermal conductivity by carbothermal reduction and two‐step sintering

High infrared emissivity of SiC-AlN ceramics at room temperature

High Electrical Resistivity of Pressureless Sintered in Situ SiC–BN Composites

Pressureless sintering of boron carbide ceramics with Al–Si additives