Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Sensitivity and limitations of plasma charging damage measurements using MOS capacitors structures

Plasma induced charging damage: From appropriate MOS test structures to antenna design rules, a comprehensive process qualification procedure

Plasma induced charging damage causing MOS device reliability lifetime degradation originating from well charging of a technology with deep trench isolation

Increased hole trapping in gate oxides as latent damage from plasma charging

Capacitance Measurement for Evaluating the Initial Top-Electrode-Damage-Induced Degradation of Organic Devices

Modeling of Surface Damage at the Si/SiO$_2$-interface of Irradiated MOS-capacitors

Effects of Non-Fatal Electrostatic Discharge on the Threshold Voltage Degradation in Nano CMOS Devices

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Negative charge injection to a positively charged SiO2 hole exposed to plasma etching in a pulsed two-frequency capacitively coupled plasma in CF4/Ar

Breakdown Voltage of Ultrathin Dielectric Film Subject to Electrostatic Discharge Stress

Breakdown modes of capacitively coupled plasma II: unsustainable discharges

Lifetime of thin oxide and oxide-nitride-oxide dielectrics within trench capacitors for DRAMs

Single-Event Upset Responses of Metal–Oxide–Metal Capacitors and Diodes Used in Bulk 65-Nm CMOS Analog Circuits

High energy electrons induced by nonlinear effect in synchronized dual-level radio frequency pulsing capacitively coupled plasmas

Investigation on Capacitance Collapse Induced by Secondary Capture of Acceptor Traps in AlGaN/GaN Lateral Schottky Barrier Diode

Impact of Process on Gate Leakage Current and Time-Dependent Dielectric Breakdown Failure Mechanisms of 4H-SiC MOS Capacitors

Wide range detector of plasma induced charging effect for advanced CMOS BEOL processes

Measurement of Plasma Etch-Induced Damage to Silicon Beneath Si0 2 Layer: Effective Range of Plasma Etch Damage Through Si0 2

Ionization Damage Effects of Pulse Discharge Circuit Switched by Anode-Short MOS-Controlled Thyristor

A New Implementation Approach for Reliability Design Rules against Plasma Induced Charging Damage from Well Configurations of Complex ICs

Characterization of Gate Leakage and Reliability of Normally-OFF GaN MOSFET with LPCVD-SiN<sub><i>x</i></sub>/PEALD-AlN Dual Gate Dielectric and <i>In-Situ</i> H<sub>2</sub>(15%)/N<sub>2</sub>(85%) Plasma Pretreatment