Abstract:The aim of the present paper is to review our work on plasma‐surface interactions during the etching of silicon gates in low pressure high density HBr/Cl2/O2 based plasmas. In integrated circuit manufacturing, the transfer of patterns onto the polysilicon layer relies on the formation of a passivation layer on sidewalls of the etched features, which protects the silicon gate sidewall fromisotropic etching. At the same time, a layer with an almost identical chemical composition is also deposited on the reactor walls and can modify the process parameters by changing the radicals' surface loss probability. In this work we use a new “plasma etching‐sputtering” diagnostic technique, involving a subsequent “mild etching” of the layer deposited on the chamber walls by a few % SF6‐containing Ar plasma. Thus we investigate the chemical composition of this layer. This chemical composition is deduced from the time variation of the gas phase concentration of different atoms and radicals, the etch products of the wall deposited layer, monitored during the “mild etching” of the layer by time‐resolved optical emission spectroscopy and mass spectrometry. Optical absorption spectroscopy and mass spectrometry have been employed to characterize the HBr/Cl2/O2 plasma, currently used for the gate etching, and to estimate the absolute flux of neutral and ionic deposition precursors reaching the reactor walls. It comes out that the silicon wafer etch byproducts, SiClx radicals (x < 2) and SiOyCl+x ions, are the main depositing agents. Finally, the chemical topography analysis method, based on the X‐ray photoelectron spectroscopy, has been used to determine the chemical composition of the layer formed on the sidewalls of the silicon etched features. We show that the layers deposited on the sidewalls and on the chamber walls are both silicon oxyhalogenides (SiOyClx) compounds, formed by the subsequent oxidation of the deposited silicon chloride etching by‐products. (© 2004 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)

Measurement of Plasma Etch-Induced Damage to Silicon Beneath Si0 2 Layer: Effective Range of Plasma Etch Damage Through Si0 2

Isotropic Etch for SiO2 Microcantilever Release with ICP System

Sub-damage-threshold plasma etching and profile tailoring of Si through laser-stimulated thermal desorption

Parametric modeling and measurement of silicon etching in a high density chlorine plasma

Monte Carlo simulation and measurement of silicon reactive ion etching profiles

Low-damage etching of poly-Si and SiO 2 via a low-energy electron beam in inductively coupled CF 4 plasma

ELECTROLYTE ELECTROREFLECTANCE (EER) SPECTROSCOPY OF ION IMPLANTED SILICON LAYER

Correlation and Interaction between Sidewall Passivation and Chamber Walls Deposition During Silicon Gate Etching

Dry Etch Damage in N-Type Crystalline Silicon Wafers Assessed by Deep-Level Transient Spectroscopy and Minority Carrier Lifetime

In situ measurements of HCl during plasma etching of poly-silicon using a diode laser absorption sensor

Oxide Or Metal Interface Damage Improvement Of Deep Silicon Etch Process By Low Power Rf Of Low Frequency

Insitu Energy Dispersive-X-Ray Reflectivity Measurements of H Ion-Bombardment on Sio2/Si and Si

Ultradeep, low-damage dry etching of SiC

Surface chemistry and damage in the high density plasma etching of gallium arsenide

Mass spectrometric study of plasma etching

Effect of process parameters on sidewall damage in deep silicon etch

Negative charge injection to a positively charged SiO2 hole exposed to plasma etching in a pulsed two-frequency capacitively coupled plasma in CF4/Ar

Methods to Protect Silicon Microstructures from the Damages in Deep Reactive Ion Etching

Flux based modeling and simulation of dry etching for fabrication of silicon deep trench structures

A Novel Technique for Measuring Etch Rate Distribution of Si

A study on the etching characteristics of atmospheric pressure plasma for single-crystal silicon wafer