Abstract:Ultrathin gate and tunnel oxides in MOS devices are subjected to high-field stress during device operation, which degrades the oxide and eventually causes dielectric breakdown. Oxide reliability, therefore, is a key concern in technology scaling for ultra-large scale integration (ULSI). Here we provide critical new insight into oxide degradation (and consequently, reliability) by a systematic study of five technologically relevant parameters, namely, stress-current density, oxide thickness, stress temperature, charge-injection polarity (gate versus substrate), and nitridation of pure oxide. For all five parameters, a strong correlation has been observed between oxide degradation and the generation of new traps (distinct from the filling of intrinsic traps). Further, we observe that this correlation is independent of the trap polarity (positive versus negative). Based on this correlation, and based on the fundamental link between electronic properties and atomic structure, a physical-damage model of dielectric breakdown has been proposed. The concept of the physical-damage model is that the oxide suffers dielectric breakdown when physical damage due to broken bonds forms a defect-filled filamentary path in the oxide, that conducts excessive current. A good monitor of this physical damage is trap generation, which we believe is caused by physical bond breaking in the oxide and at the interface. The model has been quantified empirically by the correlation between trap generation and Q/sub bd/.<>

A New Implementation Approach for Reliability Design Rules against Plasma Induced Charging Damage from Well Configurations of Complex ICs

Plasma induced charging damage causing MOS device reliability lifetime degradation originating from well charging of a technology with deep trench isolation

Plasma induced charging damage: From appropriate MOS test structures to antenna design rules, a comprehensive process qualification procedure

Sensor-Driven Reliability and Wearout Management

Increased hole trapping in gate oxides as latent damage from plasma charging

Nondestructive Dciv Method to Evaluate Plasma Charging Damage in Ultrathin Gate Oxides

Design and Analysis of an Area-Efficient High Holding Voltage ESD Protection Device

Design for Reliability of SiC-MOSFET-Based 1500-V PV Inverters with Variable Gate Resistance

Novel Approach Toward Plasma Enhancement in Trench-Insulated Gate Bipolar Transistors

A Comprehensive study of reliability improvement for 65nm Cu/Low-k process

Sensitivity and limitations of plasma charging damage measurements using MOS capacitors structures

Predicting plasma charging damage in ultra thin gate oxide by using nondestructive DCIV technique

Wide range detector of plasma induced charging effect for advanced CMOS BEOL processes

Gate-induced Drain Leakage Current Enhanced by Plasma Charging Damage

Recent Progress in Understanding the Instability and Defects in Gate Dielectrics

Mechanism of Plasma Charging Damage on Ultrathin Gate Oxide

Challenges and Perspectives for Vertical GaN-on-Si Trench MOS Reliability: From Leakage Current Analysis to Gate Stack Optimization

Correlation Between Gate Induced Drain Leakage and Plasma Induced Interface Traps

Correlation of trap generation to charge-to-breakdown (Q/sub bd/): a physical-damage model of dielectric breakdown

Designing tungsten armoured plasma facing components to pulsed heat loads in magnetic fusion machines

Dielectric Charging Induced Drift in Micro Device Reliability-a Review.