Abstract:The small gate overvoltage margin is a key reliability concern of the GaN Schottky-type p-gate high electron mobility transistor (GaN SP-HEMT). Current evaluation of gate reliability in GaN SP-HEMTs relies on either the DC bias stress or pulse I-V method, neither of which resembles the gate voltage (VGS) overshoot waveform in practical converters. This work develops a new circuit method to characterize the gate robustness and reliability in GaN SP-HEMTs, which features a resonance-like VGS ringing with pulse width down to 20 ns and an inductive switching concurrently in the drain-source loop. Using this method, the gate's single-pulse failure boundary, i.e., dynamic gate breakdown voltage (BVDYN), is first obtained under the hard switching (HSW) and drain-source grounded (DSG) conditions. The gate's switching lifetime is then tested under the repetitive VGS ringing, and the number of switching cycles to failure (SCTF#) is fitted by Weibull or Lognormal distributions. The SCTF# shows a power law relation with the VGS peak value and little dependence on the switching frequency. More interestingly, the gate's BVDYN and lifetime are both higher in HSW than those in DSG, as well as at higher temperatures. Such findings, as well as the gate degradation behaviors in a prolonged overvoltage stress test, can be explained by the time-dependent Schottky breakdown mechanism. The gate leakage current is found to be the major precursor of gate degradation. At 125 oC and 100 kHz, the VGS limits for a 10-year lifetime are projected to be ∼6 V and ∼10 V under the DSG and HSW conditions, respectively. These results provide a new qualification method and reveal new physical insights for gate reliability and robustness in p-gate GaN HEMTs

Gate reliability enhancement of p-GaN gate HEMTs with oxygen compensation technique

High V th and Improved Gate Reliability in P-GaN Gate HEMTs with Oxidation Interlayer

Normally-off GaON/p-GaN Gate HEMTs with Selective Plasma Oxidation: from Structural Characterization, Performance Improvement to Physical Mechanism

Normally-off GaN HEMTs with InGaN P-Gate Cap Layer Formed by Polarization Doping

Normally-off GaON/p-GaN gate HEMTs with using selective plasma oxidation: from structural characterization, performance improvement to physical mechanism

Improving Gate Reliability of 6-in E-Mode GaN-Based MIS-HEMTs by Employing Mixed Oxygen and Fluorine Plasma Treatment

p-GaN Gate HEMTs With 10.6 V Maximum Gate Drive Voltages by Mg Doping Engineering

Gate Leakage Suppression and Breakdown Voltage Enhancement in p-GaN HEMTs using Metal/Graphene Gates

Reliability Improvement of Ge Pmosfets with Al2O3 Dielectric by Ozone Post Annealing

Gate Reliability and its Degradation Mechanism in the Normally OFF High-Electron-Mobility Transistors With Regrown p-GaN Gate

Gate Robustness and Reliability of P-Gate GaN HEMT Evaluated by a Circuit Method

Improved Vth Stability and Gate Reliability of GaN-Based MIS-HEMTs by Employing Alternating O2 Plasma Treatment

Simulation and analysis of enhancement-mode AlGaN/GaN HEMT with P-I-N junction gate

Improved Performance of Fully-Recessed Normally-off LPCVD SiN/GaN MISFET Using N2O Plasma Pretreatment

Influence of Mg doping level at the initial growth stage on the gate reliability of p-GaN gate HEMTs

Enhanced Performance of Low-Leakage-Current Normally off P-Gan Gate HEMTs Using NH3 Plasma Pretreatment

High-Performance Normally-Off ${\rm Al}_{2}{\rm O}_{3}/{\rm GaN}$ MOSFET Using a Wet Etching-Based Gate Recess Technique

Threshold Voltage Stability Enhancing Technology for p-GaN HEMTs Using Hybrid Gate Structure

High-VTH E-Mode GaN HEMTs with Robust Gate-Bias-Dependent VTH Stability Enabled by Mg-Doped P-Gan Engineering

A Novel Atomic-Level Post-Etch-Surface-Reinforcement Process for High-Performance p-GaN Gate HEMTs Fabrication

Normally-OFF p-GaN Gate Double-Channel HEMT With Suppressed Hot-Electron-Induced Dynamic ON-Resistance Degradation