Abstract:β‐Si3N4 ceramics with an additive oxide system of 1 wt% MgO and 3 wt% Re2O3 (Re = Gd, La, Y and Yb) were fabricated by liquid phase sintering at 1950°C under nitrogen pressure of 748 kPa. Starting α‐Si3N4 powder with 10 vol% rod‐like β‐Si3N4 seed crystallites and an extended sintering time from 5 to 40 h resulted in the formation of bimodal microstructure composed of fine matrix grains and large grains. The 40 h‐sintered specimens of pseudo ternary β‐Si3N4‐MgO‐Gd2O3 system exhibited enhanced thermal conductivity of 127.2 ± 2.5 W m−1 K−1 associated with a degradation of the fracture strength from 1008.0 ± 38.0 to 491.7 ± 32.0 MPa, which was due to the formation of coarse‐grained aggregates that acted as both fracture origin as well as a thermal conductive pathway. The theoretical thermal conductivity was predicted for the sintered specimens by using equations based on a mean‐field micromechanics model to estimate the effective thermal conductivity of each component of binary composites. The calculation results suggested that the thermal conductivity of the large β‐Si3N4 grains (≥ 2 μm in diameter) was relatively high and estimated to be in the range of 175 to 191 Wm−1 K−1.The improved thermal conductivity of the 40 h‐sintered specimens was further discussed for the series of β‐Si3N4‐MgO‐Re2O3 systems based on the nanostructure characterization results obtained by the high‐resolution transmission electron microscopy and scanning transmission electron microscopy‐energy dispersive X‐ray spectrometry analyses. This article is protected by copyright. All rights reserved

Effects of AlN and rare earth fluorides on the thermal conductivity of SiC ceramics with impedance spectroscopy analysis

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effects of AlN Content and Sintering Atmospheres on the Thermal Conductivity of Hot-Pressed SiC Ceramics

High infrared emissivity of SiC-AlN ceramics at room temperature

Effect Of Rare-Earth Additives On Thermal Conductivity, Mechanical And Electrical Properties Of Silicon Nitride Ceramics

Effect of CeO2, Dy2O3, Yb 2O3 and y2O3 additives on thermal conductivity of silicon nitride ceramics

Thermal Conductivity and Mechanical Property of Si<sub>3</sub>N<sub>4</sub> Ceramics Sintered with CeF<sub>3</sub>/LaF<sub>3</sub> Additives

Thermal Conductivity and Mechanical Property of Si<sub>3</sub>N<sub>4</sub> Ceramics Sintered with CeF<sub>3</sub>/LaF<sub>3</sub> Additives

Effect of Rare Earth Additives on Properties of Silicon Nitride Ceramics

Fluoride doped SiC/Si3N4 composite as a high thermal conductive material with enhanced mechanical properties

Thermal Conductivity of AlN Ceramics with CaF2-YF3 Addition

Fabrication of Si3N4 ceramics with improved thermal conductivity by carbothermal reduction and two‐step sintering

Thermal Conductivity of AlN Ceramics Sintered with CaF2 and YF3

Thermal conductivity improvement in Si3N4 ceramics via grain purification

Effect of YF3 on densification behavior and thermal conductivity of AlN ceramics with Y2O3–YF3 additives under reducing atmosphere

The effect of additives on sintering behavior and strength retention in silicon nitride with RE-disilicate

High Thermal Conductivity in Pressureless Densified SiC Ceramics with Ultra-Low Contents of Additives Derived from Novel Boron–carbon Sources

Effects of Y2O3 and Yttrium Aluminates As Sintering Additives on the Thermal Conductivity of AlN Ceramic Substrates

Effect Of Aln Content On The Pressureless Sintering Behaviors Of Sic-Aln Multiphase Ceramics

Electrical properties of SiC-AlN ceramics pressureless sintered under N2 atmosphere

Microstructure and thermal conductivity of aluminium nitride with (CaY)F3 as the sintering aid

Effects of AlN and rare earth fluorides on the thermal conductivity of SiC ceramics with impedance spectroscopy analysis

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effects of AlN Content and Sintering Atmospheres on the Thermal Conductivity of Hot-Pressed SiC Ceramics

High infrared emissivity of SiC-AlN ceramics at room temperature

Effect Of Rare-Earth Additives On Thermal Conductivity, Mechanical And Electrical Properties Of Silicon Nitride Ceramics

Effect of CeO2, Dy2O3, Yb 2O3 and y2O3 additives on thermal conductivity of silicon nitride ceramics

Thermal Conductivity and Mechanical Property of Si&lt;sub&gt;3&lt;/sub&gt;N&lt;sub&gt;4&lt;/sub&gt; Ceramics Sintered with CeF&lt;sub&gt;3&lt;/sub&gt;/LaF&lt;sub&gt;3&lt;/sub&gt; Additives

Thermal Conductivity and Mechanical Property of Si<sub>3</sub>N<sub>4</sub> Ceramics Sintered with CeF<sub>3</sub>/LaF<sub>3</sub> Additives

Effect of Rare Earth Additives on Properties of Silicon Nitride Ceramics

Fluoride doped SiC/Si3N4 composite as a high thermal conductive material with enhanced mechanical properties

Thermal Conductivity of AlN Ceramics with CaF2-YF3 Addition

Fabrication of Si3N4 ceramics with improved thermal conductivity by carbothermal reduction and two‐step sintering

Thermal Conductivity of AlN Ceramics Sintered with CaF2 and YF3

Thermal conductivity improvement in Si3N4 ceramics via grain purification

Effect of YF3 on densification behavior and thermal conductivity of AlN ceramics with Y2O3–YF3 additives under reducing atmosphere

The effect of additives on sintering behavior and strength retention in silicon nitride with RE-disilicate

High Thermal Conductivity in Pressureless Densified SiC Ceramics with Ultra-Low Contents of Additives Derived from Novel Boron–carbon Sources

Effects of Y2O3 and Yttrium Aluminates As Sintering Additives on the Thermal Conductivity of AlN Ceramic Substrates

Effect Of Aln Content On The Pressureless Sintering Behaviors Of Sic-Aln Multiphase Ceramics

Electrical properties of SiC-AlN ceramics pressureless sintered under N2 atmosphere

Microstructure and thermal conductivity of aluminium nitride with (CaY)F3 as the sintering aid

Thermal Conductivity and Mechanical Property of Si<sub>3</sub>N<sub>4</sub> Ceramics Sintered with CeF<sub>3</sub>/LaF<sub>3</sub> Additives