Abstract:In the present work, under the theoretical framework of interface fracture mechanics, the interfacial delamination of molded underfill (MUF) encapsulated flip-chip (FC) packages is studied intensively by means of finite element simulation via virtual crack closure technique (VCCT). The crack propagation driving force, in terms of the strain energy release rate (SERR) is calculated by finite element analyses. Then, the components of Mode I strain energy release rate (G II ) and Mode II strain energy release rate (G II ) are used to determine complex stress intensity factors (SIFs) and the associated phase angle at the interface. However, due to the oscillatory nature of the stresses at the crack tip, the results of Gi and Gn are usually not converging when the element size decreases by using VCCT. Thus, the mesh independent technology must be used to evaluate the phase angle in interface crack analysis. To this end, four different methods, which are independent of parameter Δ (i.e., the crack extension size used in VCCT), are adopted to obtain the phase angle. Meanwhile, the values of the phase angle and SERR subjected to different thermal histories are calculated and the differences among these values are compared. It is found that the zero-stress temperature of the molded underfill flip-chip (MUF FC) package is very important for obtaining reasonable and correct simulation results, in particular, below this temperature the crack tip penetration occurs between the upper and lower surfaces of an embedded crack at the interface. A frictionless contact pair should be applied so as to prevent the inter-penetration of the crack. Whereas above the zero-stress temperature, no inter-penetration occurs. So, there is no need to apply the contact pair to calculating phase angles and SIFs. Furthermore, the effect of viscoelasticity of MUF on the delamination driving force in packages has also been investigated, which shows that the viscoelasticity can effectively alleviate the delamination driving force in MUF encapsulated FC packages.

Fractures of Low-K Materials in a RF Package with Integrated Passive Device Based on TGV

The Characterization of Low-K Thin Films and Their Fracture Analysis in a WLCSP Device

Measuring the Fracture Toughness of Low-K Thin Films Used in Advanced Packaging

Fractures of Ultra-Low-k Material in a Chip During a Flip-Chip Process

Physical Study of Low-frequency TDDB Lifetime Deterioration in Advanced FinFETs

Finite-Ground Thin-Film Microstrip Interconnects (tfmis) and Their Power Handling Capabilities over Ultra-Wide Frequency Ranges

Thermo-Mechanical Reliability of Micro-joints in a RF Packaging with Through Glass Via (TGV) Interposer

The Energy Release Rate of the Micro-Cracks in a Ultralow-K Chip During the Flip Chip Process

The Stress Analysis and Parametric Studies for the Low-K Layers of a Chip in the Flip-Chip Process.

Structural integrity optimization of 3D TSV package by analyzing crack behavior at TSV and BEOL

Assess Low-K/ultralow-k Materials Integrity by Shear Test on Bumps of a Chip

Finite Element Simulation Study of Interfacial Crack Propagation in the Underfilled FC-BGA Package

Thermal Stress Analysis for the Low-k Dielectric Layers of Cu Interconnects in a 45 nm Chip

Interfacial Delamination Characterization and Thermo-mechanical Reliability of Stacked Die Package by Finite Element Analysis

Failure Mechanisms Investigation of Through Glass Via (TGV) under Thermal Annealing and Shock

Optimization of Passivation and Top Metal Layer Crack in Temperature Cycle Test of RF-LDMOS

An Extensive Simulation Study of the Interfacial Delamination in Molded Underfill Flip-Chip Packages by Finite Element Method Based on Virtual Crack Closure Technique

Thermal Stress Analysis of the Low-K Layer in a Flip-Chip Package

Initial Thermal Stress and Strain Effects on Thermal Mechanical Stability of Through Silicon Via

Mechanical Properties of the Low-K Material Measured by Tensile Tests

Characterization and Imaging of Localized Thickness Loss in GFRP with Ka-Band Microwave Open-Ended Waveguides