Abstract:Sub-millimeter thick phase change material (PCM) composites have been utilized in the thermal management of micro-electronics serving as a novel thermal interfacial material. However, there is a lack of appropriate measuring methods and precise data for the thin-film PCM composites' intrinsic thermal conductivity, as well as the thermal contact resistance (TCR) at interfaces between those thin-films and metal. In this work, the out-of-plane thermal conductivity of thin-film PCM35, which is a paraffin composite showing the melting point of 35 °C, was first gauged through the commercialized transient plane source (TPS) method, followed by a correction process to deduct the TCR between thin films/temperature sensor interfaces. The direct TPS readings were corrected based on the proportional relation between samples' thickness and inherent thermal resistance. An improved steady-state heat flow apparatus designed for thin-walled samples was then utilized to examine the reliability of the corrected TPS technique, with a relative deviation between them being only ∼7%. In order to test the applicability of the corrected TPS method, the thermal conductivities of thin polytetrafluoroethylene films were also determined. Furthermore, the TCR between thin PCM35 film and thin 1060Al plate was identified by performing the improved steady-state apparatus. The contribution of overheated PCM35 film on fitting the interfacial voids and reducing the TCR were elucidated, which can guide the thermal design with the use of such thin-film PCMs.

Finite-Ground Thin-Film Microstrip Interconnects (tfmis) and Their Power Handling Capabilities over Ultra-Wide Frequency Ranges

Wide-band characterization of average power handling capabilities of some microstrip interconnects on polyimide and polyimide/GaAs substrates

Frequency-Dependent Maximum Average Power-Handling Capabilities of Single and Edge-Coupled Microstrip Lines on Low-Temperature Co-Fired Ceramic (ltcc) Substrates

The Frequency-Dependent Average Power Handling Capability Of Metal-Insulator Semiconductor (Mis) Microstrip Interconnects

Electromagnetic-Thermal Characterization Of On On-Chip Coupled (A)Symmetrical Interconnects

FDTD modeling of 3D metal-LTCC structures for RF(MM)ICs

Performance degradation of some on-chip finite-ground coplanar waveguide (FGCPW)-built passive devices at high temperature

Multiphysics Characterization of Polymer‐filled Through‐silicon Vias (pf‐tsvs) for Three‐dimensional Integration

Wideband Average Power Handling Capability of Coupled Microstrips on Polyimide and Polyimide∕gaas Substrates

A Broadband Permeability Measurement of Fetan Lamination Stack by the Shorted Microstrip Line Method

High-Frequency Electrothermal Characterization of TSV-Based Power Delivery Network

Modeling and Characterization of On‐Chip Interconnects

Transient Electrothermal Analysis of Multilevel Interconnects in the Presence of ESD Pulses Using the Nonlinear Time-Domain Finite-Element Method

Wideband Description of the Finite-Ground Coplanar Waveguide-Type Structures with Discontinuities

Electrothermal Cosimulation of 3-D Carbon-Based Heterogeneous Interconnects

Improved circuit model for coplanar-waveguide to microstrip-line transition on silicon substrate

Millefeuille-Inspired Thermal Interface Materials based on Double Self-Assembly Technique for Efficient Microelectronic Cooling and Electromagnetic Interference Shielding

Determination on the thermal conductivity and thermal contact resistance of thin composite phase change films as a thermal interfacial material

A Study on the Electromagnetic–Thermal Coupling Effect of Cross-Slot Frequency Selective Surface

Preparation, Microstructure and Thermal Properties of Aligned Mesophase Pitch-Based Carbon Fiber Interface Materials by an Electrostatic Flocking Method

Research on Effective Area of Surface Resistance Measurement of Superconducting Thin Film at Microwave Frequencies