Abstract:Ultrawide bandgap β-(Al x Ga 1 −x ) 2 O 3 vertical Schottky barrier diodes on (010) β-Ga 2 O 3 substrates are demonstrated. The β-(Al x Ga 1 −x ) 2 O 3 epilayer has an Al composition of 21% and a nominal Si doping of 2 × 10 17 cm −3 grown by molecular beam epitaxy. Pt/Ti/Au has been employed as the top Schottky contact, whereas Ti/Au has been utilized as the bottom Ohmic contact. The fabricated devices show excellent rectification with a high on/off ratio of ∼10 9 , a turn-on voltage of 1.5 V, and an on-resistance of 3.4 mΩ cm 2 . Temperature-dependent forward current-voltage characteristics show effective Schottky barrier height varied from 0.91 to 1.18 eV while the ideality factor from 1.8 to 1.1 with increasing temperatures, which is ascribed to the inhomogeneity of the metal/semiconductor interface. The Schottky barrier height was considered a Gaussian distribution of potential, where the extracted mean barrier height and a standard deviation at zero bias were 1.81 and 0.18 eV, respectively. A comprehensive analysis of the device leakage was performed to identify possible leakage mechanisms by studying temperature-dependent reverse current-voltage characteristics. At reverse bias, due to the large Schottky barrier height, the contributions from thermionic emission and thermionic field emission are negligible. By fitting reverse leakage currents at different temperatures, it was identified that Poole–Frenkel emission and trap-assisted tunneling are the main leakage mechanisms at high- and low-temperature regimes, respectively. Electrons can tunnel through the Schottky barrier assisted by traps at low temperatures, while they can escape these traps at high temperatures and be transported under high electric fields. This work can serve as an important reference for the future development of ultrawide bandgap β-(Al x Ga 1 −x ) 2 O 3 power electronics, RF electronics, and ultraviolet photonics.

A Method for Fabricating Au/n-Al_(0.3)Ga_(0.7)N Lateral Schottky Diodes

A Study of Al0.3Ga0.7N Metal-semiconductor-metal UV Photodiodes

Al 0.40 in 0.02 Ga 0.58 N Based Metal-Semiconductor-metal Photodiodes for Ultraviolet Detection

AlGaN MSM UV Photodetector

High Performance Lateral Schottky Diodes Based on Quasi-Degenerated Ga 2 O 3

Demonstration of Al0.85Ga0.15N Schottky Barrier Diode with > 3 Kv Breakdown Voltage and the Reverse Leakage Currents Formation Mechanism Analysis

Schottky-type GaN-based UV photodetector with atomic-layer-deposited TiN thin film as electrodes

AlGaN-based metal–semiconductor–metal photodiodes fabricated with nonplanar structure geometry for ultraviolet light detection

A Back-Illuminated Al0.42 Ga0.58 N/Al0.40 Ga0.60 N Heterojunction P-I-n Solar-Blind UV Photodetector

AlGaN-based Schottky Barrier Deep Ultraviolet Photodetector Grown on Si Substrate

Al x Ga 1- x N solar-blind photodetectors grown by low pressure MOCVD

Low Dark Current GaN Schottky UV Photodiodes Using Oxidised IrNi Schottky Contact

Bias-Selective Dual-Operation-Mode Ultraviolet Schottky-Barrier Photodetectors Fabricated on High-Resistivity Homoepitaxial GaN

Effect of Asymmetric Schottky Barrier on GaN-based Metal-Semiconductor-metal Ultraviolet Detector

Low dark current and internal gain mechanism of GaN MSM photodetectors fabricated on bulk GaN substrate

GaN Lateral Schottky Diodes with High Baliga's Figure-of-Merit Utilizing Self-Terminated, Low Damage Anode Recessing Technology.

Highly sensitive and cost-effective metal-semiconductor-metal asymmetric type Schottky metallization based ultraviolet photodetecting sensors fabricated on n-type GaN

Ultrawide bandgap vertical β-(AlxGa1−x)2O3 Schottky barrier diodes on free-standing β-Ga2O3 substrates

Ni/Au Schottky Diodes on Alxga1-Xn (0.7 < X < 1) Grown on Aln Single Crystal Substrates

Fabrication and investigation of AlGaN-based Schottky barrier diode

Electrical Characteristics and Photodetect Mechanism of TiO2/AlGaN/GaN Heterostructure-Based Ultraviolet Detectors with Schottky Junction