Abstract:At present, the technology of single phase ground fault line selection in small current earthing system is relatively mature, but when a single phase ground fault occurs in the system, the non fault phase voltage increases, which is likely to lead to breakdown of the non fault phase insulation weak point, forming a second ground fault, which turns into a cross line different-phase successive fault. For the detection of cross line different-phase successive fault, there are still some problems with the current line selection device. Often, only the first ground fault can be detected, while the second ground fault is not handled. When a cross line different-phase successive fault occurs on site, the line selection device often only selects the first ground fault line, and the staff judges another fault line, which results in a long fault duration and long power recovery time. It is not conducive to the safe and stable operation of the distribution network, so further research is needed for the detection of cross line different-phase successive fault. This article combines real fault cases and simulation data on site to analyze the causes and development process of cross line different phase successive fault. It also analyzes the changes in various electrical quantities during the process of transitioning from single-phase grounding faults to cross line different phase successive fault, and analyzes the impact of cross line different-phase successive fault on existing small current grounding line selection devices, Finally, improvement suggestions were proposed to address the occurrence of cross line different-phase successive fault.

Cause Identification of Single-line-to-ground Fault in Distribution System

Research on a Line Protection Method for DC Distribution System Based on Parameter Identification

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Root-Cause Identification of Single Line-to-Ground Fault in Urban Small Current Grounding Systems Based on Correlation Dimension and Average Resistance

Typical Fault Cause Recognition of Single-Phase-to-Ground Fault for Overhead Lines in Nonsolidly Earthed Distribution Networks

Study on High Impedance Grounding Fault Protection for Personal Safety Guard in Distribution Grid

An Identification Method for Asymmetric Faults With Line Breaks Based on Low-Voltage Side Data in Distribution Networks

Identification of Permanent Fault at Transmission Lines with Shunt Reactors Based on Waveform Correlation

Fault Line Identification Of Single Line To Ground Fault For Non-Effectively Grounded Distribution Networks With Double-Circuit Lines

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

Fault Location Analysis of Ungrounded Distribution System Based on Residual Voltage Distribution

Single Line-to-Ground Fault Type Multilevel Classification in Distribution Network Using Realistic Recorded Waveform

Typical Fault Characteristics Analysis of Distribution Network

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Identification of Single-phase Grounding Fault Type in Distribution Network Based on VMD and SVM

Single Line-to-ground Fault Location and Information Modeling Based on the Interaction between Intelligent Distribution Equipment

The Impact of Cross Line Different-Phase Successive Faults on Fault Detection Devices

Study on Locating Techniques of Single-phase Grounding Fault in Distribution Network

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Self-healing of single-phase grounding fault for power distribution lines

FAULT LINE SELECTION IN THE NON-SOLID EARTHED NETWORK BASED ON THE MODEL IDENTIFICATION METHOD