Abstract:This paper establishes a transient equivalent circuit of cross‐line same‐phase successive grounding faults, and analyses the characteristics of zero‐sequence current. Then, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed. Finally, a method for faulty line detection based on cross‐correlation distance and transient energy is proposed and different fault conditions verify the effectiveness of proposed method. Currently, theoretical analysis of single‐phase grounding (SPG) faults in low‐current grounding systems has reached a high level of refinement, and the corresponding detection methods have matured. However, there is a significant lack of research on successive grounding (SG) faults, particularly in the area of detecting cross‐line same‐phase successive grounding (CSSG) faults in arc suppression coil grounding systems. To address these issues, a novel faulty line detection method based on transient characteristics of CSSG is proposed. Firstly, a transient equivalent circuit is established, and the characteristics of transient zero‐sequence current (ZSC) are theoretically analysed. Secondly, variational mode decomposition (VMD) is employed to extract low and high‐frequency information from intrinsic mode functions (IMFs). Subsequently, a fault initiation criterion based on kurtosis theory and the Teager‐Kaiser energy operator (TKEO) is proposed, which can accurately detect the occurrence time of secondary faults. Finally, a method for faulty line detection based on cross‐correlation distance (CCD) and transient energy (TE) is proposed. The results of PSCAD simulation under different conditions and field test affirm the accuracy of the analysis and the effectiveness of the proposed method.

Root-Cause Identification of Single Line-to-Ground Fault in Urban Small Current Grounding Systems Based on Correlation Dimension and Average Resistance

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

Cause Identification of Single-line-to-ground Fault in Distribution System

Typical Fault Cause Recognition of Single-Phase-to-Ground Fault for Overhead Lines in Nonsolidly Earthed Distribution Networks

A Novel Fault Location Method for High Impedance Grounding Fault in Distribution Network

Corrosion Fault Diagnosis for Substation's Grounding Grid Based on Micro Method

Transient Features Analysis of Cross-Line Same-Phase Successive Ground Faults in Distribution Network

High-Resistance Grounding Fault Detection and Line Selection in Resonant Grounding Distribution Network

Faulty line detection for cross‐line same‐phase successive ground faults in distribution network based on transient characteristics

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Fault Section Identification of the Power Cables in Urban Distribution Networks by Amplitude Differences Between the Zero-sequence Currents and Those Flowing in Cable Sheaths and Armors

Multi-Source Data-Cooperated Neutral Low-Resistance Grounding Cable Grid Faulty Segment Identification

Study on Locating Techniques of Single-phase Grounding Fault in Distribution Network

Analysis of Fault Characteristics of Distribution Network with PST Loop Closing Device under Small Current Grounding System

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

Failure Mechanism Analysis of High Resistance Grounding Fault Protection in Distribution Network

Research on single-phase grounding fault location of distribution network with DG

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

The Impact of Cross Line Different-Phase Successive Faults on Fault Detection Devices

An Identification Method for Asymmetric Faults With Line Breaks Based on Low-Voltage Side Data in Distribution Networks

A faulty line detection method for single phase-to-ground fault in resonant grounding system with CTs reversely connected