Abstract:Reliability and safety are the most important indicators in the electric system. When a ground fault occurs, the electrical equipment and personnel will be greatly threatened. Due to the zero-sequence voltage/current sensor networks applied in the system, the fault identification and diagnosis technology are developing rapidly, including the application of ground fault suppression. A flexible grounding system (FGS) is a new technology applied to arc extinguishing in medium and high voltage electric distribution networks. Its characteristic is that when the single-phase ground fault occurs, the power-electronic-based device is put into the electric system to compensate and suppress the ground point current to be close to zero in a very short time. In order to implement the above process, the corresponding faulty feeder identification method needs to meet the requirements of rapidity and accuracy. In this article, based on the real-time sampled data from the zero-sequence current/voltage sensors, an improved faulty feeder identification method combining wavelet packet transform (WPT) and grey T-type correlation degree is proposed, which features both accuracy and rapidity. The former is used to reconstruct the transient characteristic signal, and the latter is responsible for calculating and comparing the similarity of relative variation trend. Simulation results verify the rationality and effectiveness of the proposed method and analysis.

An Identification Method for Asymmetric Faults With Line Breaks Based on Low-Voltage Side Data in Distribution Networks

Research on a Line Protection Method for DC Distribution System Based on Parameter Identification

Single-phase-to-ground Fault Detection with Distributed Parameters Analysis in Non-Direct Grounded Systems

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

A New Approach for Single-Phase-to-Ground Fault Detection in Mid-Voltage Systems Using Low-Voltage Sensors

Faulty Line-Section Identification Method for Distribution Systems Based on Fault Indicators

Identification of Permanent Fault at Transmission Lines with Shunt Reactors Based on Waveform Correlation

Fault Location Method for Distribution Network Based on Synchronous Measurement

An Earth Fault Diagnosis Method Based On Online Dynamically Calculated Thresholds for Resonant Ground Systems

Cause Identification of Single-line-to-ground Fault in Distribution System

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

A novel online monitoring method of ground fault in tree form distribution networks based on power line carrier devices

Single-phase Grounding Fault Line Selection Method of Ring Distribution Network Based on Classification Method

Single Line-to-ground Fault Location and Information Modeling Based on the Interaction between Intelligent Distribution Equipment

Single Line-to-Ground Fault Type Multilevel Classification in Distribution Network Using Realistic Recorded Waveform

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Faulty Feeder Identification Based on Data Analysis and Similarity Comparison for Flexible Grounding System in Electric Distribution Networks

Fault Line Identification Of Single Line To Ground Fault For Non-Effectively Grounded Distribution Networks With Double-Circuit Lines

Fault Section Identification of the Power Cables in Urban Distribution Networks by Amplitude Differences Between the Zero-sequence Currents and Those Flowing in Cable Sheaths and Armors

Current spectral norm and phase variation based fault region identification for active distribution network

A Novel Fault Identification Method for HVDC Transmission Line Based on Stransform Multi-Scale Area